Abstract:The glycerol generated as a by-product in the production of biodiesel could be used as a renewable raw material to economically promote the production process. The catalytic conversion of glycerol to a product with higher added value, such as glycerol carbonate, has attracted great interest in the chemical, pharmaceutical, and lithium battery industries, among others, due to its low toxicity, hydration capacity, and biodegradability. Layered-double hydroxide (LDH) materials, the precursors of the catalysts, were synthesized by a direct coprecipitation method to incorporate a third metal ion in addition to magnesium and aluminum ions. This method is the easiest regularly applied technique to design these low cost anionic nanoclay. The atomic percentage of Cu, Zn, or Ni incorporated was 15% of the Mg load in the material. The synthesis atomic ratio, (M 2+ +Mg 2+ )/Al 3+ had a constant value of 3, where M represents the transition metal incorporated. LDHs produced the corresponding mixed metal oxides by thermal decomposition. These materials have excellent properties for reactions catalyzed by the basic sites, high surface area, homogeneous cation dispersion, and thermal stability. The physicochemical material properties were characterized by XRD, N 2 sorption, MP-AES, TPD-CO 2 , SEM, and XPS. The mixed oxides were evaluated in the catalytic conversion of glycerol to glycerol carbonate. The addition of Cu, Ni, or Zn to the matrix of Mg and Al produced changes in its physicochemical properties and mostly in the catalytic activity. X-ray diffractograms of LDHs showed the typical characteristic structure of layers even with metallic ions of Cu, Ni, or Zn incorporated, because their ionic radii are similar to that of the Mg ion, 0.69, 0.73, and 0.74 Å, respectively. The obtained mixed oxides showed a high catalytic activity towards the conversion of glycerol to glycerol carbonate under mild reaction conditions, a 1:2 ratio of glycerol:ethylene carbonate and solvent free. Relative yields higher than 80% were obtained, attributable to an adequate distribution of basicity and textural parameters. The catalysts were used in successive reaction cycles without significant loss of activity.

Robust Iridium Coordination Polymers: Highly Selective, Efficient, and Recyclable Catalysts for Oxidative Conversion of Glycerol to Potassium Lactate with Dihydrogen Liberation

Highly efficient Ni-Mn/SiO<sub>2</sub> catalyst for the selective hydrogenation of biomass-derived levulinic acid to -valerolactone under mild conditions

Efficient Hydrogenation of Biomass Oxoacids to Lactones by Using Nhc-Iridium Coordination Polymers As Solid Molecular Catalysts

Recent Progress on Bimetallic Catalysts for the Production of Fuels and Chemicals from Biomass and Plastics by Hydrodeoxygenation

Interface Synergy Between IrOx and H-ZSM-5 in Selective C–O Hydrogenolysis of Glycerol Toward 1,3-Propanediol

Selective Catalytic Dehydrogenative Oxidation of Bio-Polyols to Lactic Acid

Acceptorless dehydrogenation of glycerol catalysed by Ir(III) complexes with carbohydrate‐functionalised ligands: a sweet pathway to produce hydrogen and lactic acid

Enhanced recycling performance of bimetallic Ir-Re/SiO2 catalyst by amberlyst-15 for glycerol hydrogenolysis

Recent Progress in Catalyst Development of the Hydrogenolysis of Biomass-Based Glycerol into Propanediols-A Review

Oxidation of glycerol to a lactic, glycolic acid mixture using a Li, Ni, Mn, Co oxide catalyst and p-TsOH—SnCl2 catalyzed polymerization to poly(lactic-co-glycolic acid)

Selective Transformation of Vicinal Glycols to alpha-Hydroxy Acetates in Water via a Dehydrogenation and Oxidization Relay Process by a Self-Supported Single-Site Iridium Catalyst

Zinc Glycerolate: an Unconventional Heterogeneous Catalyst for the Glycerolysis of Fatty Acids in Biodiesel Production

Selective oxidation of glycerol over supported noble metal catalysts

Conversion of carbohydrate biomass to γ-valerolactone by using water-soluble and reusable iridium complexes in acidic aqueous media.

Dehydrogenative Oxidation of Alcohols by Reusable Iridium Catalysts with a Cooperative Polymer Ligand

Isolated Iridium Sites on Potassium‐Doped Carbon‐nitride wrapped Tellurium Nanostructures for Enhanced Glycerol Photooxidation

Iridium-Catalyzed Selective Cross-Coupling of Ethylene Glycol and Methanol to Lactic Acid

Ir–Re Alloy As a Highly Active Catalyst for the Hydrogenolysis of Glycerol to 1,3-Propanediol

Selective Hydrogenolysis of Glycerol to 1,2-Propanediol Catalyzed by Supported Bimetallic PdCu-KF/γ-Al2O3

Highly Efficient Process for the Conversion of Glycerol to Acrylic Acid via Gas Phase Catalytic Oxidation of an Allyl Alcohol Intermediate

Mixed oxides from calcined layered double hydroxides for glycerol carbonate production to contribute to the biodiesel economy