Abstract:A thorough numerical investigation was carried out to examine the heat transfer characteristics within a rectangular channel integrated with metal foam blocks for solar air heating applications. The study employed numerical simulations using the extended Darcy–Forchheimer model with the assumption that there exist local thermal nonequilibrium conditions within the porous foam region. Four configurations, denoted as P–A, P–P, A–P, and A–A, were explored based on the presence or absence of foam blocks relative to the heated section. The study meticulously analyzed the influence of key parameters, such as the number of foam blocks (N = 1–5), permeability (quantified by pore density, ω = 10 ‐ 30 PPI ), and Reynolds number (Re = 4000 ‐ 16 , 000 ), on the thermohydraulic performance. The results were promising, indicating a significant increase in the average Nusselt number (Nu ) with the inclusion of foam blocks, albeit accompanied by an undesirable increase in the friction factor. Among the various configurations, the P–A arrangement, where porous blocks are situated at the entrance of the heating channel, exhibited superior thermal performance. Furthermore, the optimal heat transmission rate was attained with a single porous block (N = 1) in the P–A configuration, at a Reynolds number of 16,000 and high permeability (ω = 10 PPI ). Conversely, the maximum friction factor was observed with five porous blocks (N = 5) in the A–P configuration, at a Reynolds number of 4000 and low permeability (ω = 30 PPI ). The exhaustive analysis of thermohydraulic performance was evaluated using the performance evaluation criterion (PEC), which optimizes the trade‐off between increased heat transfer rate and consequent pressure loss. The P–A arrangement, particularly with higher permeability and a minimal number of porous blocks, demonstrated the highest PEC value of 2.71, representing a significant 171% improvement compared with an empty channel. This study underscores the effectiveness of strategically placing and optimizing metal foam blocks to improve the thermal performance of heat exchanger systems.

Optimizing of a metal foam-assisted solar air heater performance: a thermo-hydraulic analysis of porous insert placement

Optimizing heat transfer within a rectangular channel through intermittent metal foam block configurations: A numerical study

Heat and fluid flow analysis of metal foam embedded in a double-layered sinusoidal heat sink under local thermal non-equilibrium condition using nanofluid

Multi-objective optimization of porous foam structure to enhance energy performance of flat plate solar collectors

Experimental Study of the Effect of Porous Media on the Performance of Single-Pass Solar Air Heater

Numerical analysis of a solar air heater with offset transverse ribs placed near the absorber plate

Assessing the effects of different finned absorbers with swirl flow on the performance of solar air heater

Investigation of thermal performance and entropy generation rate of evacuated tube collector solar air heater with inserted baffles and metal foam: A CFD approach

Performance optimization of triple tube heat exchanger using aluminum metal foam: A comprehensive numerical investigation

Performance evaluation of a partially-filled porous foam cylindrical tubular receiver realizing Ni foam material reduction

Turbulent flow-thermal-thermodynamic characteristics of a solar air heater with spiral fins

Numerical Simulation of the Thermal Performance of a Tubular Solar Air Heater

Numerical analysis of the heat transfer enhancement by using metal foam

Optimal arrangements of a heat sink partially filled with multilayered porous media employing hybrid nanofluid

Exploring nusselt number and friction factor correlations for sphere-shaped roughness elements on the absorber to enhance solar air heater efficiency

Energy and exergy experimental analysis for innovative finned plate solar air heater

Heat transfer enhancement in a counter-flow sinusoidal parallel-plate heat exchanger partially filled with porous media using metal foam in the channels’ divergent sections

Experimental study on the thermal performance of a solar air heater integrated with multi-geometry arrangements over the absorber plate

Optimizing thermal performance in tube-in-tube heat exchangers with metal foam inserts: experimental and RSM analysis

Comparison of convective heat transfer in metal foam-filled channels of three different cross-sections

Heat transfer characteristics of the flat plate integrated with metal foam of varying thickness using an unconfined circular air-jet impingement