Abstract:BACKGROUND: Descriptions of glenoid deformities in glenohumeral osteoarthritis (GHOA) have focused on the axial plane. Less is known regarding arthritic glenoids with higher amounts of superior inclination and little evidence exists to guide management of inclination or combined version-inclination deformity when performing anatomic total shoulder arthroplasty (aTSA). We hypothesized that biplanar deformities (BD) would be present in a higher proportion of GHOA patients than previously appreciated, and these deformities would be difficult to adequately reconstruct with contemporary aTSA implants.METHODS: A retrospective query was performed of GHOA patients indicated for TSA 2012-2017 with a computed tomography (CT) scan within three months of surgery. Images were uploaded to three-dimensional software for automated measurements. Glenoids with superior inclination ≥10˚, retroversion ≥20˚ were considered to have BD. Walch classification was determined, C-type glenoids were excluded. Rotator-cuff muscle cross-sectional area (CSA) was measured and fatty infiltration graded. Glenoids with BD were virtually planned for aTSA with correction to neutral inclination and version, then 5˚ superior inclination and 10˚ retroversion.RESULTS: Two-hundred sixty-eight shoulders in 250 patients were included; average age 65 years, 67% male. There were no differences in inclination between Walch types (p=0.25). Twenty-nine shoulders with BD were identified (11%). These deformities were not associated with age (p=0.47) or gender (p=0.50) but were skewed towards Walch B-type, specifically B2 (p=0.03). Acromial index and posterior humeral head subluxation were higher in BD patients (p=0.04, p<0.001, respectively). Biplanar deformities had similar cuff CSA compared to those without but were less frequently associated with fatty infiltration of the subscapularis (p=0.05). When correcting to neutral version and inclination, 41% BD could not be reconstructed. Of those that could, 94% required augmented implants. When correcting to 5˚ superior inclination and 10˚ retroversion, 10% could not be reconstructed. Of those that could, 58% required augmented implants. With partial correction, augment use was predicted by retroversion >26˚ (p=0.009). Inclination did not predict augment use (p=0.90). Final implant position commonly involved unseating in the posterosuperior quadrant and cancellous exposure in the anteroinferior quadrant.CONCLUSIONS: This retrospective CT-based study of 268 shoulders with GHOA found a 11% prevalence of BD. These deformities were commonly associated with Walch B2 wear patterns. Virtual aTSA planning showed a high failure rate (41%) when correcting to neutral version and inclination. Posteriorly augmented implants were frequently required, and often still involved unseating in the posterosuperior quadrant, increased cancellous exposure in the anteroinferior quadrant, and vault perforation.

Effective glenoid track: A novel concept for shoulder instability

The Global Track Concept for Assessment of Engaging Hill-Sachs Defects in Anterior Shoulder Instability

Validating the Glenoid Track Concept Using Dynamic Arthroscopic Assessment

Glenoid Track Width Is Smaller Under Dynamic Conditions: An In Vivo Dual-Fluoroscopy Imaging Study

Management of glenoid bone loss with impaction and structural bone grafting in reverse shoulder arthroplasty

Defining Critical Humeral Bone Loss: Inferior Craniocaudal Hill-Sachs Extension as Predictor of Recurrent Instability After Primary Arthroscopic Bankart Repair

Objective calculation of glenoid bone loss in anterior shoulder instability based on the contour of the posteroinferior quadrant using the best-fit circle method: an accurate and reproducible evaluation

Longer peripheral-track lesions are associated with instability after arthroscopic Bankart repair

Accuracy and reliability of imaging modalities for studying bipolar bone loss in anterior shoulder instability: A systematic review

Early Clinical Efficacy of Small Incision Reduction and Superior Closed Pin Fixation of Goss-Ideberg Type III Glenoid Fractures using X-ray and CT Scan

Characteristics of High-Risk Bipolar Bone Loss Lesions Using 3-Dimensional Imaging

Management of bone loss in anterior shoulder instability

Three-Dimensional (3D) Animation and Calculation for the Assessment of Engaging Hill-Sachs Lesions With Computed Tomography 3D Reconstruction

Bipolar Bone Loss in Male Athletes With Traumatic Anterior Shoulder Instability: An Evaluation Using a New Scoring System

Comparison of the Glenoid Index by Computed Tomography With Magnetic Resonance Imaging

A Review and a Free Bone Graft Technique

Quantifying bone loss and lateralization with standardized baseplate versus augmented baseplates

Arthroscopic Anatomic Glenoid Reconstruction in the Unstable Shoulder: Technique, Pearls, and Pitfalls

Clinical Outcomes and Graft Resorption After Metal-Free Bone Block Suture Tape Cerclage Fixation for Recurrent Anterior Shoulder Instability: A Computed Tomography Analysis

Three-dimensional analysis of biplanar glenoid deformities: What are they and can they be virtually reconstructed with anatomic total shoulder arthroplasty implants?

Comparing Access to Engaging Hill-Sachs Lesions Between the Modified Posterior Deltoid Split Approach and Standard Deltopectoral Approach for Bone Grafting