Abstract:A methodology for simultaneous (not sequential) determination of Cd and Ni in powder chocolate samples by high-resolution continuum source graphite furnace atomic absorption spectroscopy (HR-CS-GF-AAS) and slurry sample analysis was developed. Acid digestion of the samples was not necessary, considering the high total fat content of this type of matrix (above 10 %), and no apparent deterioration of the graphite tubes was even observed once these samples were subjected to analysis. Despite the volatilities of both elements are quite different, simultaneous quantification was achieved using a slow heating ramp atomization, covering a convenient and wide temperature gradient for Cd volatilization at low temperatures and subsequent atomization of Ni at elevated temperatures, using the same heating program without an apparent change in sensitivity. This slow heating ramp was essayed between 200 and 1500 °C·s-1 and optimized at 400 °C·s-1, achieving the simultaneous measuring of Cd in the principal line (228.8018 nm) and using a secondary for Ni (228.9984 nm). No stop events for sequential changes in wavelength or temperature additional steps were involved in the method and molecular spectral interferences overlapping the analyte signals were corrected appropriately by a pragmatic strategy taking advantage of the fine structure signals adjacent to analyte signals within the same spectrum recorded. Palladium matrix modifier and aqueous standards were used for the calibration and determination of both elements in the samples. The method accuracy was successfully confirmed using a reference material (NIST SRM 1573a). An improvement in the sensitivity of Ni was found using a greater number of pixels for signal integration, central and five adjacent pixels (CP ± 5), while a lengthening of the linear range of Cd was obtained by using an attenuated signal (±2) or using only one pixel (CP). The limits of detection were 0.027 μg g-1 and 0.22 μg g-1 for Cd and Ni respectively by this simple methodology using aqueous standards for calibration and the simultaneous determination of both elements in the same measurement. The respective limits of quantification for Cd and Ni were 0.090 and 0.72 μg g-1 and the relative standard deviations in samples (n = 5) were about 4-20% and 0.3-11% for Cd and Ni respectively. The optimized method was used for the determination of both elements in real samples purchased from retail supermarkets finding variable concentrations between 0.5 and 5.7 μg g-1 for Cd and 2.1-10.9 μg g-1 for Ni, comparable to levels reported in the literature referred to elsewhere in the world.

A new method based on extraction induced by emulsion breaking for determination of Co and Ni in chocolate bars by graphite furnace atomic absorption spectrometry

Application of electrocolorimetric extraction for the determination of Ni(II) ions in chocolate samples: A green methodology for food analysis

Use of slow atomization ramp in high resolution continuum source graphite furnace atomic absorption spectrometry for the simultaneous determination of Cd and Ni in slurry powdered chocolate samples

Separation and determination of iron(Ⅱ),cobalt(Ⅱ) and nickel(Ⅱ) by HPLC after cloud point extraction with TAN.

Development of a novel method based on extraction mediated by a semipermeable membrane to determine Cd and Cr in sugar by graphite furnace atomic absorption spectrometry

Determination of Ultra-Trace Cobalt in Water Samples Using Dispersive Liquid-Liquid Microextraction Followed by Graphite Furnace Atomic Absorption Spectrometry

An efficient green microextraction method of Co and Cu in environmental samples prior to their flame atomic absorption spectrometric detection

Separation of cobalt and nickel via solvent extraction with Cyanex-272: Batch experiments and comparison of mixer-settlers and an agitated column as contactors for continuous counter-current extraction

Determination of Trace Phosphorus in Cobalt-Niobium-zirconium Alloy by Inductively Coupled Plasma Atomic Emission Spectrometry

Systematic Study for Determining As, Pb, Cd, and Se in Steel and Nickel Alloy Samples by GF AAS: Circumventing Matrix Interference with Extraction Based on Micellar Separation

Direct Determination of Nickel and Manganese in Cobalt Naphthenate by Microemulsion Flame Atomic Absorption Spectrophotometric Method

Sensitive isotope dilution liquid chromatography/electrospray ionization tandem mass spectrometry method for the determination of acrylamide in chocolate.

Application of Extraction Induced by Emulsion Breaking for Trace Multi-Element Determination in Jet Fuel by Inductively Coupled Plasma-Mass Spectrometry

A novel automatic flow-batch extraction induced by emulsion breaking platform for on-line copper determination in edible oil samples by atomic absorption spectrometry

Determination of cobalt in food by magnetic solid-phase extraction (MSPE) preconcentration by polyaniline (PANI) and polythiophene (PTH) coated magnetic nanoparticles (MNPs) and microsample injection system – flame atomic absorption spectrometry (MIS-FAAS)

Multivariate optimization for the determination of cadmium and lead in crude palm oil by graphite furnace atomic absorption spectrometry after extraction induced by emulsion breaking

Functionalized nanodiamonds with NiCoFe layered double hydroxides used as a novel adsorbent in dispersive solid phase microextraction for Pb(II) determination in juice samples

Simultaneous extraction of trace amounts of cobalt, nickel and copper ions using magnetic iron oxide nanoparticles without chelating agent

A green solventless temperature-assisted homogeneous liquid–liquid microextraction method based on 8-hydroxyquinoline simultaneously as complexing agent and extractant for preconcentration of cobalt and nickel from water and fruit juice samples

Green Surfactant Assisted-Solidified Floating Organic Drop Micro-Extraction for the Preconcentration of Trace Cobalt and Determination by Flame Atomic Absorption Spectrometry

SIMULTANEOUS DETERMINATION OF COPPER AND NICKEL WITH DDTC SPECTROPHOTOMETRY IN THE PRESENCE OF TRITON X-100