Abstract:Nano-materials are increasingly being used as modified binder for improve the performance of cementitious materials. In this paper, nano-SiO2 and nano-Al2O3 were incorporated into the geopolymers formed by the mixture of construction solid waste (recycled concrete fine powder) and industrial solid waste (slag). The effects of the type and content of nanomaterials on the early reaction kinetics, physical and mechanical properties and microstructure of geopolymer composites were explored. Results show that the addition of nanomaterials mainly affected the dissolution stage of geopolymerization, played a nucleation effect and improved the reaction rate. The promotion effect of nano-Al2O3 was slightly greater than that of nano-SiO2. Based on the results of JMAK model, the formation of geopolymers composites was an one-dimensional heterogeneous nucleation control reaction, which followed a plate-like structure thickening mechanism. The addition of nanomaterials shortened the setting time. The incorporation of nano-Al2O3 was beneficial to improve the fluidity of geopolymer. Furthermore, the addition of the two nanomaterials could improve the compressive strength of geopolymers. The compressive strength tended to first increase and then decrease with increasing nano-SiO2 or nano-Al2O3 content. The optimal mixing ratio of nano-silica and nano-alumina were 1.2% and 1.6% respectively, and the 28-day compressive strengths were both 59.05 MPa, which were 23.35% higher than that without nano-materials. XRD and SEM-EDS analysis indicate that the incorporation of nanomaterials had no impact on the type of final products, but increased their number, particularly calcium-based gel products. The internal structure of geopolymer with nanomaterials was more dense and uniform than that without nanomaterials. The MIP observed that the addition of the two nano-materials reduced the porosity in the matrix, the number of macropores and the pore fractal dimension. The pore fractal dimension of geopolymer was negatively correlated with the compressive strength.

Preparation, characterization, electrical conductivity, and life cycle assessment of carbon nanofibers-reinforced Ecuadorian natural zeolite-based geopolymer composites

Geopolymer composites reinforced with natural Fibers: A review of recent advances in processing and properties

Engineering and Life Cycle Assessment (LCA) of Sustainable Zeolite-Based Geopolymer Incorporating Blast Furnace Slag

Carbon nanotubes and nanohorns in geopolymers: A study on chemical, physical and mechanical properties

Impact of Surface Treatment on the Strengthening of Geopolymer Composites Reinforced with Short Sisal Fibers

The Different Properties of Geopolymer Composites Reinforced with Flax Fibers and Carbon Fibers

Residual water and interfacial bonding effects on the mechanical performance of CNT/fly ash geopolymer binder

Reaction kinetics, mechanical properties, and microstructure of nano-modified recycled concrete fine powder/slag based geopolymers

Investigation on Physical Behavior, Impermeability and Micromechanism of Engineering Geopolymer Composites Modified with MWCNTs

Synthesis and Performance Evaluation of Nano-Calcium Carbonate-Modified Geopolymers Incorporating Fly Ash and Manganese Slag: A Comprehensive Investigative Study

Synthesis of geopolymer-zeolite composite from municipal solid waste incineration fly ash and their performance for CO 2 adsorption

Characterization of fly ash–based geopolymer composites reinforced with biomass-derived Phoenix sp. fibers

Use of pumice stone and silica fume as precursor material for the design of a geopolymer

Mechanochemical fabrication of geopolymer composites based on the reinforcement effect of microfibrillated cellulose

Effects of PVA fibers and multi-walled carbon nanotubes reinforcement on uniaxial compression fatigue properties of Engineered geopolymer composites

Study on the Conductivity and Pressure Sensitivity Performance of Carbon Fiber Geopolymer

Mechanical strength and mineralogical properties of fiber-reinforced geopolymer composites with multi-walled carbon nanotubes

Synthesis of nano-alumina and their effect on structure, mechanical and thermal properties of geopolymer

Cleaner geopolymer prepared by co-activation of gasification coal fly ash and steel slag: durability properties and economic assessment

Enhancing the properties of geopolymer concrete using nano-silica and microstructure assessment: a sustainable approach

Experimental Investigation on the Mechanical and Fracture Evaluation of Carbon Fiber-Reinforced Cementitious Composites with Nano-Calcium Carbonate