Abstract:Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, Ahead of Print. Acrylonitrile butadiene styrene (ABS), a petroleum-based thermoplastic, is widely used in various industry. It is important to make product costs without reducing the wear characteristics of products. For this reason, over the past 20 years, researchers have focused on improving product performance by reducing material weight. The literature has limited information about the tribological properties of the ABS polymer samples produced with fused deposition modelling. In this study, gyroid-patterned ABS samples with different infill densities (25%, 50%, and 75%) were produced and the effect on the wear properties of the samples was investigated. The main aim of the study is to show the infill density effect on wear and friction performance of the samples and find the coefficient of friction values. So, this study is one of the first studies which investigated wear and friction properties of ABS polymer produced as gyroid pattern with different infill densities. The study might also be used to have an initial information whether ABS polymer can be used in additive manufacturing systems for the joint components. As the performance indicator, diameter deviation, hardness, surface roughness, test temperature, friction coefficient, weight loss, and wearing surface results of the samples were evaluated. The results show that infill density is an important property that effect the tribological and heating characteristic of ABS samples. The friction and heat of the samples increase by increasing infill density. According to the tribological test results, the highest coefficient of friction and friction temperature were reached in the samples with 75% infill density.

Biaxial Thermo–Mechanical Response of ABS Sheet Above Tg Using DIC–Based Bubble Inflation Technique

DIC/DSI Based Studies on the Local Mechanical Behaviors of HR3C/T92 Dissimilar Welded Joint During Plastic Deformation

Research on aluminum alloy sheet thermoplastic deformation behavior based upon warm bulging test

A novel mechanical attachment for biaxial tensile test: Application to formability evaluation for DP590 at different temperatures

Large tensile deformation behavior of PC/ABS alloy

Viscoelastic Analysis of the Radiant Heating Process of ABS Sheets

3D Non-Newtonian deposition flow and thermal simulations to evaluate the scale-up potential for material extrusion of single walled ABS parts with overhang

Rate-dependent Large Deformation Behavior of PC/ABS

Process-informed simulation of Big-Area Additive Manufacturing (BAAM) of polymers

Experimental Investigation of the Deformation Behavior of Abs Resin at Elevated Temperature and High Strain Rate

Study of Dynamic Failure Behavior of a Type of PC/ABS Composite

Deformation of PC/ABS alloys at elevated temperatures and high strain rates

The Application of DIC Method in the Investigation of Polymer Tensile Behaviors

Thermoplastic gas pressure forming of bulk metallic glass sheets under biaxial tension

Study of self-heating and local strain rate in polyamide-6 and short fibre glass/polyamide-6 under tension through synchronised full-field strain and temperature measurements

Analysis of the Rotation Bending Test Method and Characterization of Unidirectional Carbon Fiber-Reinforced Polycarbonate Tapes at Processing Temperatures

Coupled Temperature–displacement Modelling of Injection Stretch-Blow Moulding of PET Bottles Using Buckley Model

Experimental and Modeling Study of the Compressive Behavior of PC/ABS at Low, Moderate and High Strain Rates

Measurement and analysis of deformation behavior of thermoplastic elastomer tube subjected to biaxial tensile stress under loading and unloading

Deformation Response and Constitutive Modeling of PC, ABS and PC/ABS Alloys under Impact Tensile Loading

Tribological characteristics of ABS structures with different infill densities tested by pin-on-disc