Abstract:In this study, a thermo-mechanical finite element model was developed to investigate the thermal deformation during a stamping process of an automotive body part. The stamping process was decomposed into the 6 sub-steps to reflect the physical boundary conditions found in an actual stamping equipment. The temperature distributions of the actual stamping process were measured by two thermography cameras. The developed numerical procedure was then validated against the measured temperature distributions. Due to the limited accessibility to the actual equipment and high reflectivity of the involved material, the reflectivity index for the thermal imaging device (i.e., emissivity) was experimentally determined. A sample specimen made of the same material with the die material was built. The thermocouples were placed underneath the specimen surface through holes and used to directly measure the surface temperature distribution. The emissivity for the sample specimen was then determined by comparing the temperature measured by the thermocouples to the temperature measured by the thermographic camera. When the lubrication oils were spread on the sample specimen, the emissivity was set to a value 0.7. The thermal images were corrected based on the emissivity experimentally obtained and used to validate the finite element model simulation for the stamping process. With the validated finite element model, the investigation on the variation in the temperature and stress during each sub-step was performed. With the zero thermal expansion rate, the pure thermal effect on the temperature distribution was simulated. The pure thermal deformation in the Blank (i.e., target surface) was similar to the spring back distance after the blank was released from the molds. During the stamping process, the heat generation was obtained due to either friction between surfaces and plastic deformation of the target surface. We found that the plastic deformation played a critical role in the final temperature rise.

Viscoelastic Analysis of the Radiant Heating Process of ABS Sheets

Thermal Management for Thermoset Automated Fiber Placement Based on Infrared Heater Structure Arrangement

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

As-built FE Thermal Analysis for Complex Curved Structures in Automated Fiber Placement

Numerical analysis of ablative behavior of silicone resin coated carbon fabric

Biaxial Thermo–Mechanical Response of ABS Sheet Above Tg Using DIC–Based Bubble Inflation Technique

Numerical investigation of the effect of thermal gradients on curing performance of autoclaved laminates

Towards real-time finite-strain anisotropic thermo-visco-elastodynamic analysis of soft tissues for thermal ablative therapy

A combined method for analyzing the effective thermal conductivity evolution of satin weave thermoset prepregs during preforming process

Numerical Investigation of Deposition Characteristics of PLA on an ABS Plate Using a Material Extrusion Process

Numerical modeling of the thermal deformation during stamping process of an automotive body part

A Numerical Study of Thermal Degradation of Polymers: Surface and In-Depth Absorption

Establishment of rubber thermo-viscoelastic constitutive model and analysis of temperature field

A viscoelastic–viscoplastic modeling approach for amorphous polymers in vacuum forming simulation

Analysis of the deformation of a perforated sheet under thermal and tension load using finite element method

A Thermal–Elastic–Plastic Constitutive Model using the Radial Basis Function Neural Network and Application for an Energy Efficient Warm Forming Process

A three-dimensional viscoelastic analysis of thermoplastic resin matrix composite laminates during hot stamping

Tensile Behavior of Acrylonitrile Butadiene Styrene at Different Temperatures

Analysis of radiative mixed convective heat transfer for non-Newtonian fluid with heat generation/absorption phenomena

Analysis Of Dynamic And Acoustic Radiation Characters For A Flat Plate Under Thermal Environments

FEM analysis for curing temperature field of filament wound vessels