Abstract:The International Journal of Robotics Research, Ahead of Print. Wrist mobility contributes significantly to the execution of upper limb motor tasks. Despite this, current prosthetic wrists are far less advanced than other artificial joints. Typically, prosthetic wrists offer limited degrees of freedom, if any, which forces users to execute compensatory movements during task performance. This addition increases weight and complexity, two unwelcome factors in upper limb prostheses. This article presents the design of a 3-degree-of-freedom friction-lockable prosthetic wrist actuated by a single motor. The design features adaptable behavior when unlocked, promoting a gentle interaction with the environment, and enables users to adjust the hand configuration during pre-grasping phases. The proposed system was tested, combined with a hand prosthesis, and compared to a commercial rotational wrist during the execution of functional movements. Experiments involved nine able-bodied subjects and one prosthesis user. Participants also performed the experiments with their biological wrist (the intact wrist for the prosthesis user) as a control. Results showed that the lockable wrist was used actively 20% more often than the commercial solution without compromising users' execution time. Interaction tests reveal that compensatory movements are reduced when using the proposed design, resulting in closer resemblance to the control wrist's performance. The average satisfaction and usability scores were significantly higher for the proposed wrist, indicating its potential acceptance. Finally, the system was validated in a set of activities of daily living performed by the prosthesis user. The study contributes to the development of more intuitive and adaptable prostheses that can improve the quality of life of amputees.

[Ureteral stenosis of appendicular origin, observations apropos of the value of imaging].

Design and Compliance Control of Rehabilitation Exoskeleton for Elbow Joint Anchylosis

Allosteric regulation of cloned m1-m5 muscarinic receptor subtypes.

Design, Development, and Control of a Hand/Wrist Exoskeleton for Rehabilitation and Training

Modeling and Control of a Novel Variable Stiffness Three DoFs Wrist

Design and Analysis of the M3Rob: A Robotic Platform for Wrist and Hand Rehabilitation

Design and Performance Analysis of a Bioelectronic Controlled Hybrid Serial-Parallel Wrist Exoskeleton

Development of a Wearable Finger Exoskeleton for Rehabilitation

Design and development of a 3-DoF robotic wrist joint with tension amplification mechanism

Design, Development, and Testing of an Intelligent Wearable Robotic Exoskeleton Prototype for Upper Limb Rehabilitation

Design, simulation, and experimental evaluation of a light weight, and wearable cable driven ForeWrist exoskeleton robot for assistance and rehabilitation

Cloning and in vitro characterization of the grapevine fanleaf virus proteinase cistron.

Antidiabetic activity of a triterpenoid saponin isolated from Momordica cymbalaria Fenzl.

A three degrees of freedom switchable impedance myoelectric prosthetic wrist

Design and Development of a Hand Exoskeleton Robot for Active and Passive Rehabilitation

Design of a Parallel Wrist Rehabilitation Robot and Analysis of Physiological Effect on Training

Mechanism Design and Performance Analysis of a Wearable Hand Rehabilitation Robot

Development of a passive Rehabilitation Robot for the wrist joint through the implementation of an Arduino UNO microcontroller

Rosétte formation between human b lymphocytes and zymosan-C3 complexes using different complement sources.

Optimal Design of a Bilateral Stand-Alone Robotic Motion-Assisted Finger Exoskeleton for Home Rehabilitation

On the design of an exoskeleton for neurorehabilitation: design rules and preliminary prototype