Abstract:Liquified hydrogen, which is expected to be a next-generation, environmentally friendly energy source, can be used as a cryogenic refrigerant. A cryogenic precooler (a heat exchanger between air and liquified hydrogen) has been developed for the hypersonic engine in the aerospace field. It cools the incoming air compressed at the engine's air intake using liquified hydrogen (cryogenic fuel) as a refrigerant to save the core engine from heat load and improve efficiency. However, frost formation in a precooler is a severe issue. In the present study, we developed a valid numerical method for predicting frost formation on cryogenic temperature surfaces to avoid frosting problems. The feature of the present model is considering the frost growth due to fog deposition, which has not been considered in the previous models, in addition to desublimation and fog formation. We conducted verification analyses for the frosting under forced convection on a flat cold plate at −170 °C. On an ultra-low temperature plate (−170 °C), the characteristic phenomena, including frost layer separation, were reproduced, and the frost mass and height were in quantitative agreement with the experimental data. The numerical results clarified the water vapor consumption due to fog formation and the contribution of desublimation and fog deposition to frost growth. Desublimation was dominant at the front end. On the rear side, fog formation was initially significant, and its deposition was dominant. Desublimation was suppressed because fog formation consumed water vapor. After that, the dominant mechanism gradually changed from fog deposition to desublimation because fog formation was gradually suppressed with time. These results were consistent with the experimental observation. Moreover, we also confirmed the validity of the present model for frosting on a plate of −75 °C, in which the influence of fog formation and deposition differed from at −170 °C. The model developed in this research can simulate frost formation on various temperature surfaces, from general-low temperatures where only desublimation is dominant to ultra-low temperatures where fog formation and deposition have significant impacts.

Frost growth characteristics on vertical plates at ultra-low temperatures: frost separation phenomenon and surface treatment

Temperature-gradient-enabled Prohibition of Condensation Frosting on Fin Surfaces

An experimental study on the plate edge effect of frosting characteristics for horizontal flat cold plates with surface wettability considered

Experimental study of frosting on horizontal plate

Frost propagation and distribution on cold plate surface under forced convection

Experiment Study on Unsteady Frosting of Cryogenic Vertical Plate Surface under Natural Convection Conditions

Frost-Air Interface Characterization Under Natural Convection

Spatial Control of Frost Formation on Surfaces with Millimetric Serrated Features

Visual and Theoretical Analyses of the Early Stage of Frost Formation on Cold Surfaces

Frost Layer Growth Behavior Study on a Cryogenic Surface with Water Vapor Content <1000 Ppmv

Review on condensation frosting and defrosting experiments for superhydrophobic surfaces

An Experimental Study on the Frost Formation over a Flat Plate: Effect of Frosting on Heat Transfer

An experimental study on the dynamic frosting characteristics on the edge zone of a horizontal copper plate under forced convection

Experimental study on anti-frost property and edge effect of superhydrophobic surface with millimeter-scale geometries

Effect of mixed hydrophilic and hydrophobic surface coatings on droplets freezing and subsequent frost growth during air forced convection channel flows

Experimental Investigation of Frost Growth in Forced Convection

Development of a numerical model for frost formation on ultra-low temperature surfaces considering both desublimation and fog deposition

Experimental study of frosting on wavy plate

Freezing processes for a vertically copper, superhydrophobic, and hybrid patterned surface – A visualization study

Review of restraint frost method on cold surface

Visualization of cold surface frosting