Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

A novel prediction method for outlet water temperature of converter valve based on F-BP network

TransFNN: A Novel Overtemperature Prediction Method for HVDC Converter Valves Based on an Improved Transformer and the F-NN Algorithm

Primary Frequency Control Ability Evaluation of Valve Opening in Thermal Power Units Based on Artificial Neural Network

A Method for Predicting Power Loss of HVDC Converters Based on Support Vector Regression.

Prediction of Water Quality Index in Qiantang River Based on BP Neural Network Model

Predictor-Based Neural Network Finite-Set Predictive Control for Modular Multilevel Converter

A hybrid PCA-SOA-BP approach for predicting converter endpoint temperature in steelmaking

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

A Junction Temperature Monitoring Method for IGBT Modules Based on Turn-Off Voltage with Convolutional Neural Networks

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station

A Novel Method for Operation Monitoring of Thyristor Converter Based on Real‐Time Virtual Measurement of Valve Current in LCC‐HVDC

Research on the BP Neural Network Temperature Compensation Algorithm in Flow Metrology

Calculation and research of hotspot temperature analysis of converter transformer

Research on Water Source Heat Pump Control System Based on Neural Network

Power Loss Calculation Method for IGBT in Converter Valve Based on Inverse Heat Transfer Problem

A Novel Prediction Method of Short-circuit Current

Temperature Prediction of Generator Carbon Brush Based on LSTM Neural Network

Research on the Prediction of Energy-saving Potential of Traffic Tunnel Based on BP Neural Network

Distributed Parallel Computation of the 3D Electric Field in the HVDC Converter Valve Hall

Temperature and Fault Prediction of Transformer in Distribution Station Based on Digital Twin Model

Water temperature forecasting based on modified artificial neural network methods: Two cases of the Yangtze River