Abstract:A simple and highly selective flow injection on-line pre-concentration and separation-flame atomic absorption spectrometric method was developed for routine analysis of trace amounts of lead in biological and environmental samples. The selective preconcentration of lead was achieved in a wide range of sample acidity (0.075 to > or = 3 mol L(-1)HNO3) on a microcolumn (145 microL) packed with a macrocycle immobilized on silica gel. The lead retained on the column was effectively eluted with an EDTA solution (0.03 mol L(-1), pH 10.5). Three kinds of potential interferences, i.e., preconcentration inferences from metal ions with an ionic radius similar to that of Pb(II) due to their competition for the cavity of the macrocyle, elution kinetic interferences from ions which form stable complexes with EDTA due to their competition for EDTA, and interferences in the atomizer from residual matrix, were evaluated and compared in view of the read-out mode of the analyte response (peak area vs peak height), column wash step (with vs without), column capacity (50 vs 145 microL), and column shape (conical vs cylindrical). The results showed that a combination of increase in column capacity, quantitation based on peak area, and use of dilute nitric acid for column wash before elution efficiently avoid the above-mentioned potential interferences. With the use of a 145 microL column the present system tolerated up to 0.1 g L(-1) Ba(II), 1 g L(-1) Sr(II), and at least 10 g L(-1) Fe(III), Cu(II), Ni(II), Zn(II), Cd(II), Al(III), K(I), Na(I), CaII), and Mg(II) in the sample digest. Further improvement of the interference tolerance can be achieved by increasing column capacity if more complicated samples need to be analyzed. At a sample loading rate of 3.9 mL min(-1) with 30-s preconcentration, an enrichment factor of 52, a detection limit (3s) of 5 micrograms L(-1) Pb in the digest and a sampling frequency of 63 h(-1) were obtained. The precision (RSD, n = 11) at the 200 micrograms L(-1) level was 1.9%. The enrichment factor and the detection limit can be further improved by increasing sample loading rate without degradation in the efficiency due to the favorable kinetics and low hydrodynamic impedance of the present system. The analytical results obtained by the proposed method for a number of biological and environmental standard reference materials were in good agreement with the certified and recommended values.

Biohybrid Adsorbent for the Preconcentration of Lead and Its Determination in Fruit Juices by Electrothermal Atomic Absorption Spectrometry

Direct Detection of Pb2+ and Cd2+ in Juice and Beverage Samples Using PDMS Modified Nanochannels Electrochemical Sensors

Simultaneous Enrichment of Inorganic and Organic Species of Lead and Mercury in Pg L−1 Levels by Solid Phase Extraction Online Combined with High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry

Quantification of ultra-trace organolead species in environmental water by inductively coupled plasma mass spectrometry with online solid-phase extraction and high performance liquid chromatographic separation

Functionalized nanodiamonds with NiCoFe layered double hydroxides used as a novel adsorbent in dispersive solid phase microextraction for Pb(II) determination in juice samples

An Eco‐Friendly Approach for Determination of Lead in Biological Samples after Deep Eutectic Solvent Extraction

Sustainable pretreatment of blood samples using hydrophobic eutectic solvents to improve the detection of bisphenol A

Optimized ultrasound-assisted dispersive liquid–liquid microextraction for simultaneous trace multielement determination of heavy metals in environmental water samples by ICP-MS

Modified Polysulfone Nanofibers for the Extraction and Preconcentration of Lead from Aqueous Solutions

Ionic liquid-based hollow fiber liquid-phase microextraction for the determination of trace lead (II) in environmental water and tea drinks samples by graphite furnace atomic absorption spectrometry

Ionic Liquid-Solidified Floating Organic Drop Microextraction for the Preconcentration of Lead in Environmental Water Samples Prior to Its Determination with Electrothermal Atomic Absorption Spectrometry

Extraction and preconcentration of lead (II) in various water and food samples by orbital shaker-assisted magnetic solid phase extraction method using a new magnetic poly linoleic acid-polystyrene-PDMS block copolymer

Application of a macrocycle immobilized silica gel sorbent to flow injection on-line microcolumn preconcentration and separation coupled with flame atomic absorption spectrometry for interference-free determination of trace lead in biological and environmental samples

Simple Magnetic Polymeric Ionic Liquid Nanocomposite Coated Hollow Fiber Membrane for the Determination of Lead (II) and Copper (II) in Water and Fruit Juice with Microinjection Sampling-Flame Atomic Absorption Spectrometry (MIS-FAAS)

Evaluation of the use of a reflux system for sample preparation of processed fruit juices and subsequent determination of Cr, Cu, K, Mg, Na, Pb and Zn by atomic spectrometry techniques

Insights into the environmental benefits of using apple pomace for biosorption of lead from contaminated water

Headspace Solid-Phase Microextraction Coupled to Miniaturized Microplasma Optical Emission Spectrometry for Detection of Mercury and Lead.

Deep Eutectic Solvent-Based Microextraction of Lead(II) Traces from Water and Aqueous Extracts before FAAS Measurements

Determination of lead in complex sample matrices by atomic fluorescence spectrometry: optimisation of online hydride generation

Part I: A comparative study of bismuth-modified screen-printed electrodes for lead detection

Lead Removal at Trace Concentrations from Water by Inactive Yeast Cells