Abstract:This paper proposes a novel approach for monitoring multi-bolt looseness using guided waves and the cross-correlation of the wavelet energy envelope. By assessing variations in the wave packet, the looseness in multi-bolt assemblies can be estimated. First, the dispersion effects of Lamb waves were theoretically analyzed using the Rayleigh-Lamb equation. Next, the wavelet energy was derived through wavelet transform, and the Lamb wave envelope was obtained as a criterion for accurately separating the wave packet. Cross-correlation analysis was employed to quantitatively evaluate the dispersion of wave packets for varying levels of bolt looseness. A looseness index, termed the normalized decorrelation coefficient of wavelet energy (NDCWE), was defined. Then, validation experiments were conducted using a joint with five M8 bolts, each tightened to a standard torque of 42 N·m. Two piezoelectric transducers were attached to the periphery of the bolt group. Three preload conditions were tested for each bolt: fully tightened, 80% of the standard torque, and 10% of the standard torque, corresponding to no looseness (NL), minor looseness (ML), and significant looseness (SL), respectively. Results showed that when significant looseness occurs, the NDCWE value exceeds 0.4, confirming the effectiveness of NDCWE in detecting substantial reductions in bolt preload. Experiments assessing the effect of temperature revealed that temperature has a negligible effect on the waveforms of the S0 and A0 mode waves. Finally, to quantitatively evaluate the efficiency of the ultrasonic transducers, the bolt-to-sensor ratio (BSR) was introduced. In this study, the BSR reached 2.5, indicating that a single piezoelectric transducer can monitor the preload of 2.5 bolts. The proposed approach shows great potential for multi-bolt looseness monitoring.

Health Monitoring of Bolted Joints Based on Time Reversal Method

Health monitoring of bolted joints using the time reversal method and piezoelectric transducers

A bolt preload monitoring method based on the refocusing capability of virtual time reversal

Preload Monitoring of Bolted L-Shaped Lap Joints Using Virtual Time Reversal Method

Health Monitoring of Bolt Looseness in Timber Structures Using PZT-Enabled Time-Reversal Method

Bolt Looseness Detection Using SH Guided Wave and Wave Energy Transmission

Contact Acoustic Nonlinearity (Can)-Based Continuous Monitoring of Bolt Loosening: Hybrid Use of High-Order Harmonics and Spectral Sidebands

Bolt looseness detection and localization using time reversal signal and neural network techniques

Real time bolt preload monitoring using piezoceramic transducers and time reversal technique—a numerical study with experimental verification

Monitoring Method of Bolt Looseness Based on Inversion of Joint Surface Gap by Magnetic Field Change

A Review of Bolt Tightening Force Measurement and Loosening Detection

Review on recent advances in structural health monitoring paradigm for looseness detection in bolted assemblies

Continuous Monitoring of Residual Torque of Loose Bolt in a Bolted Joint

Research on Percussion-Based Bolt Looseness Monitoring under Noise Interference and Insufficient Samples

Monitoring the looseness of a bolt through laser ultrasonic

Application of subharmonic resonance for the detection of bolted joint looseness

Fault Detection Method of Bolt-joint Using Acceleration and Impedance

Multi-bolt looseness monitoring using guided waves: a cross-correlation approach of the wavelet energy envelope

Health Monitoring of Aerospace Bolted Lap Joints Using Nonlinear Ultrasonic Spectroscopy: Theory and Experiments

Study on the effect mechanism of vibration excitation parameters on bolt loosening based on an implicit monitoring method