Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Preparation and characterization of HA bonded Al2O3–MgO based castables with superior slag resistance for the working lining of Si-killed stainless steel ladles

Effect of the hydrotalcite formation on the fracture behavior and corrosion resistance of HA‐bonded alumina‐spinel castables

Corrosion mechanism of reactive MgO‐bonded Cr2O3‐bearing castables in CaO–Al2O3–Fe2O3–SiO2‐based steel‐making slag

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Influence of bonding systems on the properties of Al 2 O 3 -MgO refractory castables: Aluminate cement and alumina silica gel

Corrosion mechanism of cement-bonded Al2O3–MgAl2O4 pre-cast castables in contact with molten steel and slag

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Effect of magnesium aluminum hydrotalcite on the properties of CAC-bonded castables

Implementation of industrial waste ferrochrome slag in conventional and low cement castables: Effect of calcined alumina

Improved comprehensive properties of Al2O3-MgO-C refractories containing lightweight tabular alumina aggregates

The role of CaO and MgO incorporation in chloride resistance of sodium carbonate-activated slag

Reduction of CaO and MgO Slag Components by Al in Liquid Fe

Slag Corrosion Behavior of Novel Lightweight Magnesia Castable in a High-Basicity Slag: Role of Micropores and Nanosized Zirconia

Improved slag corrosion resistance of MgO–C refractories with calcium magnesium aluminate aggregate and silicon carbide: Corrosion behavior and thermodynamic simulation

Enhanced corrosion resistance by simultaneous refinement of pore structures and phase composition: A novel lightweight microporous alumina-rich spinel (Mg0.4Al2.4O4)

Corrosion of MgO-C with Magnesium Aluminate Spinel Addition in A Steel Casting Simulator

Simultaneous enhance of the thermal shock resistance and slag-penetration resistance for tundish flow-control refractories: the role of microporous magnesia

The critical role of aggregate microstructure in thermal shock resistance and slag resistance of Al2O3–SiC–C castable

Effect of pretreated Al-Si alloy powder on the microstructure and properties of Al 2 O 3 -SiC-C castables for iron runner

Rheological and mechanical properties of aluminosilicious cementitious materials as refractory castable binders

Effect of grinding on the hydration of hydratable alumina and properties of hydratable alumina-bonded castables