Abstract:Ni/SBA-15 meso-structured catalysts modified with chromium and CeO2 (Ni-Cr-CeO2/SBA-15) were utilized to produce hydrogen from glycerol steam reforming (GSR). The catalysts were synthesized by a one-pot hydrothermal process and extensively characterized by analytical techniques such as N2 adsorption-desorption (BET), H2-temperature programmed reduction (H2-TPR), powder X-ray diffraction (PXRD), inductively coupled plasma-optical emission spectrometry (ICP-OES), and transmission electron microscopy (TEM). The low-angle XRD reflections affirmed that the catalysts were crystalline and possessed a 2D-ordered porosity. The BET results depicted that all the catalysts exhibited a good surface area ranging from 633 to 792m2/g, and the pore sizes were consistently in the mesoporous range (between 3 and 5 nm). TEM analysis of both calcined and spent catalysts revealed that the metal active sites were embedded in the hybrid CeO2-SiO2 support. Overall, the Ni-based catalysts exhibited higher glycerol conversion -12Ni-SBA-15-99.9%, 12Ni3CeO2-SBA-15-89.4%, and 8Ni4Cr3CeO2-SBA-15-99.7%. Monometallic 12Ni/SBA-15 performed exceptionally well, while 12Cr/SBA-15 performed poorly with the highest 71.48% CO selectivity. For short-term GSR reactions, CeO2 addition to 12Ni/SBA-15 did not have any effect, whereas Cr addition resulted in a 32% decrease in H2 selectivity. The long-term stability studies of 12Ni-SBA-15 showed H2 selectivity of ~ 64% and ~ 98% glycerol conversion. However, its activity was short-lived. After 20-30 h, the H2 selectivity and conversion dropped precipitously to 40%. The doping of mesoporous Ni/SBA-15 with Cr and CeO2 remarkably enhanced the long-term stability of the catalyst for 12Ni3CeO2-SBA-15, and 8Ni4Cr3CeO2-SBA-15 catalyst which showed ~ 58% H2 selectivity and ~ 100% conversion for the entire 60 h. Interestingly, Cr and CeO2 seem to improve the shelf-life of Ni-SBA-15 via different mechanistic pathways. CeO2 mitigated Ni poisoning through coke oxidation whereas Cr bolstered the catalyst stability via maintaining a well-defined pore size, structural rigidity, and integrity of the heterogeneous framework, thereby restricting structural collapse, and hence retard sintering of the Ni active sites during the long-term 60 h of continuous reaction. Hydrogen generation from renewable biomass like glycerol could potentially serve as a sustainable energy source and could substantially help reduce the carbon footprint of the environment.

Sorption enhanced aqueous phase reforming of biodiesel byproduct glycerol for hydrogen production over Cu-Ni bimetallic catalysts supported on gelatinous MgO

Sol-Gel Preparation, Characterization and Hydrogenation Property of Silica Supported Ni Catalyst

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

Aqueous phase reforming of biodiesel byproduct glycerol over mesoporous Ni-Cu/CeO2 for renewable hydrogen production

Enhanced Hydrogen Production from Steam Reforming of Vegetable Oil over Bimodal ZrO2-SiO2 Supported Ni Catalyst

Improved Hydrogen Production by Glycerol Photoreforming over Ag2O-TiO2 Nanocomposite Mixed Oxide Synthesized by a Sol-gel Method

Comparison of gelatinous and calcined magnesia supported Ni or/and Co-based catalysts for aqueous phase reforming of glycerol

Hydrogen production from steam reforming of glycerol by Ni–Mg–Al based catalysts in a fixed-bed reactor

CO 2 reforming of biodiesel-waste glycerol on nanostructure Ni-SiO 2 .MgO catalysts for syngas production: Influence of the catalyst chemical composition

Cr and CeO2 promoted Ni/SBA-15 framework for hydrogen production by steam reforming of glycerol

Enhanced Biomass-Derived Glycerol Conversion to Syngas in the CO 2 Reforming Process: Influence of the Nickel Loading Method on Physicochemical Properties and Catalytic Performance

Hydrogen production from aqueous phase reforming of glycerol over attapulgite-supported nickel catalysts: Effect of acid/base treatment and Fe additive

Hydrogenolysis of Glycerol over NiCeZr Catalyst Modified with Mg, Cu, and Sn at the Surface Level

Renewable hydrogen production from steam reforming of glycerol by Ni–Cu–Al, Ni–Cu–Mg, Ni–Mg catalysts

Multiporous Carbon Encapsulated Ni Nanoparticles Promoting Glycerol Valorisation Towards Hydrogenation Against Rearrangement

Super solid-base supported Cu catalysts for hydrogenolysis of glycerol to 1,2-propanediol

Promoting Electrocatalytic Glycerol C─C Bond Cleavage to Formate Coupled with H2 Production Over a CuxNi2–xP Catalyst

Biodiesel Derived Glycerol Hydrogenolysis to 1,2-Propanediol on Cu/Mgo Catalysts

Glycerol steam reforming over hydrothermal synthetic Ni-Ca/attapulgite for green hydrogen generation

Renewable hydrogen production from chemical looping steam reforming of biodiesel byproduct glycerol by mesoporous oxygen carriers

Enhanced Hydrogen Production by the Catalytic Alkaline Thermal Gasification of Cellulose with Ni/Fe Dual-Functional CaO Based Catalysts