Abstract:Carbon fiber–reinforced plastics are now widely used in various industries because of its excellent properties. Although milling and drilling are the dominating processing methods for carbon fiber–reinforced plastics at present, laser beam machining, as a wear-free, contactless and flexible process, is considered a promising alternative method. However, the thermal damage is one of the most important issues for laser beam machining of carbon fiber–reinforced plastics because of the significant difference in thermal properties of carbon fiber and matrix. Water jet–guided laser technique has been proved an effective technique to reduce heat damage. Nevertheless, there are few studies about carbon fiber–reinforced plastics processing with water jet–guided laser to date. It is important to understand the mechanism of interaction between water jet–guided laser and carbon fiber–reinforced plastics. Hence, a three-dimensional finite element model was developed to investigate the transient thermal process. The influence of scanning speed on the surface appearance, heat-affected zone and shape of the cross section was illustrated. Experiments with same process parameters were conducted to validate the model. Based on the finite element model and experiments, the mechanism of material removal was explained. The epoxy is considered to be removed once it reaches the melting point and the carbon fiber is removed at the sublimation temperature. Because of the strong cooling effect of water jet, there is nearly no heat accumulation between pulses, leading to the constant heat-affected zone width at different scanning speed. The kerf sidewall is relatively vertical due to the homogeneous power distribution in water jet. The results demonstrate that water jet–guided laser cutting of carbon fiber–reinforced plastics has some advantages than traditional laser beam machining and is a potential processing method for carbon fiber–reinforced plastics.

Analysis of process-induced damage in remote laser cut carbon fibre reinforced polymers

Assessment of laser cutting parameters and heat-affected zone on microstructure and fatigue behaviour of carbon fibre-reinforced epoxy

Study on anisotropic heat transfer and thermal damage in nanosecond pulsed laser processing of CFRP

Analysis of subsurface damage during milling of CFRP due to spatial fibre cutting angle, tool geometry and cutting parameters

Effect of thermal damage on dynamic and static mechanical properties of CFRP short pulse laser hole cutting

Study of experimental and numerical simulation of high-energy laser processing on carbon fiber reinforced polymer

Investigation of the Effect of Artificial Internal Defects on the Tensile Behavior of Laser Powder Bed Fusion 17–4 Stainless Steel Samples: Simultaneous Tensile Testing and X-Ray Computed Tomography

3D photothermal reconstruction of subsurface defects in notched multidirectional CFRP laminates due to tensile fatigue loading

A Progressive Damage Model for unidirectional Fibre Reinforced Composites with Application to Impact and Penetration Simulation

Damage characterization and discrimination in laser-shocked carbon fiber reinforced polymer laminates: A mass-spring-damping model approach

Influence of Complex Geometries on Damage Tolerance of Porous Carbon Fiber Network

Multi-pass laser cutting of carbon/Kevlar hybrid composite: Prediction of thermal stress, heat-affected zone, and kerf width by thermo-mechanical modeling

Simulation of self-piercing rivetting processes in fibre reinforced polymers: Material modelling and parameter identification

Investigation of CFRP cutting mechanism variation and the induced effects on cutting response and damage distribution

Numerical Simulation of Water Jet–guided Laser Cutting of Carbon Fiber–reinforced Plastics

Open-hole Tensile Progressive Damage and Failure Prediction of Carbon Fiber-Reinforced PEEK–titanium Laminates

Investigation on damage behaviors of carbon fiber‐reinforced nylon 6 thermoplastic composite laminates using acoustic emission and digital image correlation techniques

Evaluation of heat generation using a microscopic cutting model with thermo-mechanical coupling for carbon fiber reinforced polymer composites

Analysis of Burr and Tear in Milling of Carbon Fiber Reinforced Plastic (CFRP) Using Finite Element Method

Investigation on ablative process of CFRP laminates under laser irradiations

A New Three-Dimensional Progressive Damage Model for Fiber-Reinforced Polymer Laminates and Its Applications to Large Open-Hole Panels