Abstract:In this paper, the competing requirements of material strength, casting formation and residual stress are considered in the design of a large bulkhead integral isothermal forging die using a design approach that incorporates an outer ring plus a die body. Thermal stress assembly was conducted to resolve the various manufacturing issues encountered in the production of this large-scale casting. This paper also proposes a design method for an expansion joint and material-saving holes to homogenize the cross-sectional thickness of the casting die by solving problems associated with defects and hot cracking during the casting process. The finite element method was used based on the equivalent liquid level descending method, the Niyama criterion, etc., to analyze the pouring of the sand model with different risers to choose the casting process. To resolve the occurrence of hot cracks during production, the design was optimized and the process was improved in combining with the simulation analysis result, after which carrying out another finite element analysis and by re-verifying the production process again. The results show that the simulated porosity, shrinkage and stress distribution are in accord with the practical production status. Based on the mechanical properties and a microstructure analysis, the tension strength of the K3 casting die at 950 °C is approximately 635 MPa, and the microstructures are typical dendrites. However, through the simulation, practical production, and analysis of the mechanical properties and microstructure, the die design method proposed in this paper offers benefits in solving casting forming problems and hot cracking of an integral oversized titanium bulkhead casting die, and a K3 superalloy die with a weight of 7.8 tons was successfully cast.

7-series aluminum alloy extrusion die

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Die Structure Optimization of Aluminum Alloy Wheel Low-Pressure Die Casting Based on CAE

Analysis of Forming of Automotive Drawbar and Design of the Die

Advancements in the manufacturing of dies for hot aluminum extrusion with conformal cooling channels

Extrusion of 7075 Aluminium Alloy Through Double-Pocket Dies to Manufacture a Complex Profile

Optimization of porthole extrusion die for 6063 aluminum alloy profile with thin-walled multi-cavity complex section and analysis of profile performance

Application of Artificial Intelligence Extrusion Die Model Based on Finite Element Simulation in Decorative Material Aluminum Alloy

Innovative aluminium extrusion: increased productivity through simulation

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Cold-extrusion Die Design of Subsidiary Transmission Shaft

Effect of Pocket Design on Metal Flow Through Single-Bearing Extrusion Dies to Produce A Thin-Walled Aluminium Profile

Manufacture and Properties on Prototype for Multi-metal Hot Forging Die Based on Cobalt Alloy Coating

FEM Simulation of Aluminium Extrusion Through Two-Hole Multi-Step Pocket Dies

Flash-free closed forging die

Optimization design of porthole die and study on microstructures and mechanical properties for an Al–Li alloy hollow profile

FEM-Assisted Design of a Multi-Hole Pocket Die to Extrude U-Shaped Aluminum Profiles with Different Wall Thicknesses

Physical Simulation Method for the Investigation of Weld Seam Formation During the Extrusion of Aluminum Alloys

Casting Design Optimization Using Numerical Simulation of Precision Forging Die for Large Titanium Alloy Integral Bulkhead