Abstract:The grounding grid on the outside of the epoxy insulator breaks under the long-term oxidative corrosion of moisture, fails prematurely, and may eventually develop into a breakdown failure. However, the impact of this process has not yet been discovered.In this paper, a 110 kV combined prefabricated cable joint breakdown fault is discussed. Through the inspection and comparative analysis of the faulty joint, it is speculated that the premature failure of the grounding grid causes the breakdown of the epoxy insulator. The fault process can be divided into the grounding failure stage and the insulation damage stage. In this paper, the corresponding two-dimensional electric field simulation calculation model is established, the fault development process is restored, and the possible effects of different stages is analyzed.The results show that due to the corrosive effect of moisture, when the grounding grid is broken, a floating potential will be generated on the surface of the epoxy insulator. With the expansion of the grounding failure range, the local field strength on the surface of the epoxy insulator is distorted, which will cause partial discharge. When the failure range is 220 mm, the electric field distortion of the joint reaches the maximum value of 23.3MV/m, which will destroy the insulation strength of the epoxy insulator and cause insulation breakdown, eventually leading to an accident.The research results point out the importance of the continuity of the grounding grid, and the improvement measure is proposed to reduce the occurrence of such accidents. The analysis method for cable joint failure case can provide a reference for dealing with similar accidents.

Analysis of Characteristic Quantity of Incipient Fault of Medium Voltage Cable Joints in Water-Logged Environment Based on Fluid Characteristics

Simulation and Partial Discharge Detection for Typical Defects of 10 Kv Cable the Joint

Typical Defect Simulation of 110kv Cable and Its Partial Discharge Characteristic Test

Incipient Fault Detection and Condition Assessment in DFIGs Based on External Leakage Flux Sensing and Modified Multiscale Poincare Plots Analysis

Cable Incipient Fault Identification Method Using Power Disturbance Waveform Feature Learning

Model-free underground cable incipient fault location using two-terminal zero-sequence measurements

Early Warning Of Current-Carrying Faults Based On Deterioration Assessment Of Electric Contacts

Study on a 110 kV combined prefabricated joint fault caused by premature failure of grounding grid

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Distributed Partial Discharge Detection Technology for High Voltage Cable Based on Ac Withstand Voltage

Insulation Properties and Interface Defect Simulation of Distribution Network Cable Accessories under Moisture Condition

Interface Damages of Electrical Insulation in Factory Joints of High Voltage Submarine Cables

Cable Insulation Fault Identification Using Partial Discharge Patterns Analysis

Design of fault location algorithm based on online distributed travelling wave for HV power cable

Cable Insulation Defect Prediction Based on Harmonic Anomaly Feature Analysis

A Novel Diagnosis Method for Void Defects in HVDC Mass-Impregnated PPLP Cable Based on Partial Discharge Measurement

Analysis and Countermeasure of 110KV Cable Joint Defects

Design of Partial Discharge Test Environment for Oil-Filled Submarine Cable Terminals and Ultrasonic Monitoring

Electric Field Simulation of 10kv Cable Intermediate Joint Based on Ingress Defect

Single phase to ground arcing fault identification based on wavelet packet energy