Abstract:Torrefaction is a promising technology to scale up the utilization of biomass for power purposes. The ash-related issues during biomass combustion and co-combustion are essential to be addressed, however, on which the effects of torrefaction are seldom concerned and need in-depth and comprehensive investigation. To provide useful information related, the authors conducted a series of studies. In the present work, the particulate matter (PM) emission during combustion is focused on. Three biomasses were torrefied at a fixed-bed reactor, and the elemental release and transformation during torrefaction were characterized through chemical fractionation analysis. The combustion tests of the raw and torrefied biomass and their blends with two typical coals were conducted on a drop-tube furnace at 1300°C in air. The PM 10 (particulate matter with an aerodynamic particle size below 10 μm) collected by a Dekati low-pressure impactor and PM 10+ (particulate matter with an aerodynamic particle size above 10 μm) collected by a Dekati cyclone were characterized by a scanning electron microscope equipped with energy dispersive spectrometer (SEM-EDS). The results indicate that torrefaction effectively reduces S and Cl in biomass while slightly reducing the alkalis. The contents of refractory elements (Mg, Ca, and Fe) are hardly influenced. Torrefaction promotes the transformation of AAEMs (alkaline and alkaline earth metals) into less-reactive forms (HCl-soluble and insoluble). The vaporization of alkalis, S, and Cl during biomass combustion is reduced and the retention of AAEMs into aluminosilicates is promoted after torrefaction. This reduces the emission of PM 1 (particulate matter with an aerodynamic particle size below 1 μm) from biomass combustion. During co-combustion, the PM emission largely depends on the combined effects of elemental vaporization, competing reactions (alkalis against Mg, Ca, and Fe), retention of metals into aluminosilicates, and sulfation of chlorides. The inhibited effect of torrefaction on mineral vaporization reduces the formation of PM 1 by condensation. The emission of PM 1-10 (particulate matter with an aerodynamic particle size between 1 and 10 μm) either increases due to the promoted retention of the metals in coarse particles or decreases by agglomerating into PM 10+ . Torrefaction shows a preferable performance concerning its effects on PM emission during biomass combustion and co-combustion with coal.

Effects of Excess Air and Energy Fraction on Heat Transfer for Co-firing of Eucalyptus Bark and Peanut Shell Blended Fuel in a Twin-Cyclonic Swirling Fluidized-Bed Combustor

Experimental Study of Combustion Chamber Performance Utilizing Biochar from Empty Fruit Bunch (EFB) as Fuel with Variation in Excess Air

Influence of Torrefaction on Biomass Gasification Performance in A High-Temperature Entrained-Flow Reactor

Effect of Turbulent Mixing on Combustion Behaviours of a Single Biomass Pellet

CFD investigation of the complex multiphase flow of biomass gasification in industrial-scale dual fluidized bed reactor

Feasibility of co-disposal of lignite and eucalyptus wood in coal-fired power plants: thermogravimetric characterization, typical gaseous pollutant emission characteristics, and economic analysis

Comparison of Gasification Performances Between Raw and Torrefied Biomasses in an Air-Blown Fluidized-Bed Gasifier

CFD Modelling of the Co-Gasification of Biomass and Coal Particles in Fluidised Beds

Evaluating the Impact of Wood Sawdust and Peanut Shell Mixing Ratio on Co-Combustion Performance

Characterization of Reactivity Enhancement Coal Combustion with Empty Fruit Bunches Using Thermogravimetry Analysis

Numerical simulation of effects of flue gas recirculation on biomass combustion in grate boiler

Effect of Air Equivalence Ratio on the Characteristics of Biomass Partial Gasification for Syngas and Biochar Co-Production in the Fluidized Bed

Impact of Biomass Upgrading Via Hydrothermal Treatment on Slagging and Fouling During Cofiring with Coal

Experiment and Numerical Studies of the Effect of Equivalent Ratio on Combustion Characteristics in Fluidized Bed Gasifier

EXPERIMENTAL STUDY ON BED-TO-TUBE HEAT TRANSFER COEFFICIENTS IN BUBBLING FLUIDIZED BED

Numerical Modelling of the Co-Firing of Pulverised Coal and Straw in A 300 Mwe Tangentially Fired Boiler

Effects of torrefaction on ash-related issues during biomass combustion and co-combustion with coal. Part 1: Elemental partitioning and particulate matter emission

Study of biomass gasification in an industrial-scale dual circulating fluidized bed (DCFB) using the Eulerian-Lagrangian method

Assessment of the compatibility of biomass-coal blends for cleaner energy utilization and sustainable development

CPFD numerical study on tri-combustion characteristics of coal, biomass and oil sludge in a circulating fluidized bed boiler

Exergy Analysis of a Biomass Co-Firing Based Pulverized Coal Power Generation System