Abstract:For weak grid scenario with high new energy proportion, large fluctuations of load are prone to cause low-voltage ride through. Moreover, stator transient magnetic flux will cause overvoltage and overcurrent problems in the rotor of doubly fed induction generator. Based on model predictive control, a control strategy for transient flux linkage and reactive power compensation is proposed. Firstly, regarding the issue of reactive power allocation of grid side converters (GSC) and rotor side converters (RSC), an allocation strategy is derived under minimizing winding energy loss on case of low-voltage ride through, enabling the wind energy conversion system to provide reactive power support during grid voltage recovery process. Meanwhile, an improved mixed second- and third-order generalized integrator (MSTOGI) phase-locked loop (PLL) is used to extract the positive and negative sequence components of the power grid voltage, further for RSC control. Secondly, in response to power grid faults, considering the influence of stator DC transient flux and negative sequence flux components on rotor current, by injecting rotor transient compensation current and stator flux feedforward compensation into RSC, the rotor impulse voltage and loop current are reduced. Moreover, combined with model predictive control algorithm, a control strategy of rotor current is designed. Finally, a simulation platform is built to validate the effectiveness of the proposed method based on comparing with several traditional vector control low-voltage ride through methods.

Model Predictive Control of the Open-winding PMSG System Based on Three-Dimensional Reference Voltage-Vector

3-D Vector-Based Model Predictive Current Control for Open-End Winding PMSG System With Zero-Sequence Current Suppression

Synthetic Vectors-Based Predictive Control of Dual Three-Phase PMSMs for Current Harmonics Mitigation Considering Average Deception Effect

Zero Sequence Current Suppression Strategy for Open Winding PMSG Fed by Semi-controlled Converter

Model Predictive Control of an Embedded Enhanced-Boost Z-Source Inverter

Model Predictive Control Of Semi-Controllable Open Winding Pmsg Based On Three Level Npc Converter

Model Predictive Current Control for an Open-Winding PMSM System with a Common DC Bus in 3-D Space

Improved load-adaptive control strategy for PMSG based stand-alone wind energy generation system

An Error Tracking Dead-beat Model Predictive Torque Control for Open-Winding Permanent Magnet Synchronous Motor with Common DC Bus

Dual Delay-Compensation-Based Model Predictive Control for the Semi-Controlled Open-Winding PMSM System

Zero-Sequence Current Suppression Strategy of Open-Winding PMSG System With Common DC Bus Based on Zero Vector Redistribution

Novel Topology and Control Strategy of HVDC Grid Connection for Open Winding PMSG Based Wind Power Generation System

Control Strategy for Open Winding PMSM System Supplied by the Z-source and Voltage Source Integrated Converters

Efficient Predictive Control for Dual Three-Phase PMSM Drive With Vector Transformation

Hybrid Vector Model Predictive Control for Open-winding PMSM Drives

Investigation on Open Winding Pmsg System with the Integration of Full Controlled and Uncontrolled Converter

Sensorless Control of Pmsg Based on Dual Two-Level Inverter Open Winding Configuration for Wind Turbines

Improved Model Predictive Current Control for PMSM Drives Based on Dynamic Reference Current

Virtual Voltage Vector Based Model Predictive Control for a Nine-Phase Open-End Winding PMSM With a Common DC Bus

Model Predictive Control on Transient Flux Linkage and Reactive Power Compensation of Doubly Fed Induction Wind Generator

Bilateral Four-Segment-Mode Model Predictive Control for Open-Winding PMSM Drives