Abstract:The objective of this work is to present an integral methodology to numerically model the wear phenomena by friction in a polymer–metal contact pair, showing the development of a numerical tool to implement a wear model in the commercial finite element code Abaqus. The contact pair in which this work is based corresponds to the contact between a guide shoe insert for an elevator, made of thermoplastic polyurethane elastomers (TPU), and the corresponding guide, made of steel. Tribometer tests are planned to fit the numerically implemented wear model as well as to validate it. These tests are briefly described as an introduction to the numerical fitting of the data from which the wear model is obtained. The numerical tool in which the wear model in a polymer–steel contact pair is implemented is based on a methodology that combines the use of the user subroutine Umeshmotion, which offers the possibility of implementing a wear model in any general form, several routines to result access, and the adaptive meshing technique, a mesh smoothing tool available in Abaqus based on ALE (Augmented Lagrangian Eulerian) methods. With this technique, it is possible to eliminate material during the simulation as well as to maintain a high-quality mesh throughout an analysis by allowing the mesh to move independently of the material. As the tests that are carried out in the tribometer to fit and to validate the wear model require long travel distances and a large number of cycles, a real simulation of those tests would require a huge calculation time. Therefore, to simulate the wear process equivalent to the travelled distances in the tests in an affordable simulation time, an accelerated numerical procedure of the wear process is also proposed in this work. To numerically implement the wear model, and as it is usually stated in polymers, it is previously necessary to set up a procedure for determining the relationship between the friction coefficient and the contact pressure for the material and countermaterial contact pair. Finally, a validation of the methodology with a new wear tribometer test under different conditions to those stated to characterise the model is also presented.

Tribological study of a press-fit assembling process

A Friction Evaluation Method Based on Barrel Compression Test

A wear particle-based model of friction in a polymer–metal high pressure contact

Tribological Analysis of Engineering Plastics/Steel Friction Pairs

Experimental Method of Tribological Modelling of Different Coatings of Stainless Steel

Tribological Behavior of Reinforced PTFE Composites and Un-Reinforced Polyketone-Based Materials against Coated Steel

Wear and the Transition from Static to Mixed Lubricated Friction of Sorption or Spreading Dominated Metal-Thermoplastic Contacts

Anomalous Lubrication Behavior of Metal-Polymer Tribo-Pairs

Differences in Tribological Behaviors upon Switching Fixed and Moving Materials of Tribo-pairs including Metal and Polymer

Tribological Characterisation and Modelling for the Fused Deposition Modelling of Polymeric Structures under Lubrication Conditions

FRICTION PROCESSES OF SELECTED POLYMERS SLIDING ON STEEL AND DURALUMIN IN A LUBRICANT ENVIRONMENT

Finite element implementation and validation of wear modelling in sliding polymer–metal contacts

Physicochemical Tribomechanics of Antifriction Materials Operating in Heavy-Loaded Friction Pairs in Active Lubricating Media

Tribological Performance of Additively Manufactured AISI H13 Steel in Different Surface Conditions

Pressurized environments directly influence friction and wear of dry steel contacts—Investigations in a novel high fluid pressure tribometer

The influence of metal surface composition on the tribological properties of filled PTFE/steel couples

Performance and mechanisms of different tribological thermoplastic composites in sliding contact with steel

Tribological behavior of PTFE/Nomex/phenolic composite lubricant under cold forming condition in the bearing assembly process

Impact of lubrication on the tribological behaviour of PTFE composites for guide rings application

Friction and lubrication modelling in sheet metal forming: Influence of lubrication amount, tool roughness and sheet coating on product quality