Behaviour of short columns made with conventional or FRP-confined rubberised concrete: An experimental and numerical investigation

Imad El Khouri,Reyes Garcia,Petru Mihai,Mihai Budescu,Nicolae Taranu,Ionut Ovidiu Toma,Maurizio Guadagnini,David Escolano-Margarit,Ioana Sorina Entuc,Gabriel Oprisan,Iman Hajirasouliha,Kypros Pilakoutas
DOI: https://doi.org/10.1016/j.engstruct.2024.117885
IF: 5.582
2024-03-24
Engineering Structures
Abstract:Failure of short columns in concrete buildings has been extensively reported during past earthquakes. Assessing the behaviour of short columns is challenging and often requires using time-consuming advanced numerical modelling. This article presents a new and practical Short Column Macro Element (SCME) that predicts accurately the behaviour of concrete short columns. A 1/3-scale one-storey building with short columns is subjected to lateral loading tests until failure. The experimental results from the building are then used to calibrate a numerical model in Abaqus®. It is shown that the numerical model matches well the experimental results. The experimental crack patterns and stress distribution from Abaqus® are then used to determine the load path within the short column. Based on these data, a new strut-and-tie SCME is proposed and implemented in OpenSees software to simulate accurately (within 5% accuracy) the behaviour of the short columns of the tested building. Subsequently, the frame models calibrated in OpenSees and Abaqus® are modified to examine numerically the effectiveness of highly deformable FRP-confined rubberised concrete (FRP CRuC) at increasing the deformability of short columns with different levels of FRP confinement (1, 2 or 3 layers). The numerical results show that whilst the tested building failed at a small displacement of 5.4 mm (0.43% drift ratio), the use of FRP CRuC short columns with minimal confinement (1 layer of AFRP only) increased the building's displacement by almost seven times to 37 mm (3.0% drift ratio). This also enabled more redistribution of forces to other structural members of the building. This article contributes towards the development of practical design/analysis models for short columns made of conventional concrete and FRP CRuC, which are scarce in the existing literature.
engineering, civil
What problem does this paper attempt to address?