Abstract:Ammonia (NH3) is emerging as a promising alternative fuel for longer range decarbonised heavy transport, particularly in the marine sector due to highly favourable characteristics as an effective hydrogen carrier. This is despite generally unfavourable combustion and toxicity attributes, restricting end use to applications where robust health and safety protocols can be upheld. In the currently reported work, a spark ignited thermodynamic single cylinder research engine equipped with gasoline direct injection was upgraded to include gaseous ammonia port injection fuelling, with the aim of understanding maximum viable ammonia substitution ratios across the speed-load operating map. The work was conducted under overall stoichiometric conditions with the spark timing re-optimised for maximum brake torque at all stable logged sites. The experiments included industry standard measurements of combustion, performance and engine-out emissions (including NH3 “slip”). With a geometric compression ratio of 12.4:1, it was possible to run the engine on pure ammonia at low engine speeds (1000-1800rpm) at low-to-moderate engine loads in a fully warmed up state. When progressively dropping down below a threshold load limit, an increasing amount of gasoline co-firing was required to avoid engine misfire. Due to the favourable anti-knock characteristics, pure ammonia operation was up to 5% more efficient than pure gasoline operation under stable operating regions. A maximum net indicated thermal efficiency of 40% was achieved, with efficiency tending to increase with speed and load. For the co-fuelling of gasoline and ammonia in a pure ammonia attainable operating region, it was found that addition of gasoline improved the combustion, but these improvements were not sufficient to translate into improved thermal efficiency. Emissions of NH3 slip reduced with increased gasoline co-fuelling, albeit with increased NOx. However, the reduction in NH3 slip was nearly 10 times the increase in NOx emissions. Comparing pure NH3 and pure gasoline operation, NOx reduced by ~60% when switching from pure gasoline to pure NH3 (as the latter is associated with longer and cooler combustion). Results were finally compared to those obtained a modern multi-cylinder Volvo “D8” turbo-diesel engine modified for dual fuel operation with ammonia port fuel injection, with the focus of the comparison being NH3 slip and NOx emissions.

Applicability Analysis and Combustion Simulation of Ammonia as Fuel for Marine Diesel Engine

Numerical Investigation of a Heavy Duty Compression Ignition Engine Converted to Ammonia Spark Ignition Operation

Numerical Investigation of Diesel Spray Combustion Characteristics in the Ammonia/air Atmosphere

Numerical investigation on the combustion and emission characteristics of ammonia in a low-speed two-stroke marine engine

Simulation Research on the Injection Strategy of a Diesel-Ammonia Dual-Fuel Marine Engine

Pilot diesel-ignited ammonia dual fuel low-speed marine engines: A comparative analysis of ammonia premixed and high-pressure spray combustion modes with CFD simulation

Investigation on the Potential of Using Carbon-Free Ammonia in Large Two-Stroke Marine Engines by Dual-Fuel Combustion Strategy

Optimizations of energy fraction and injection strategy in the ammonia-diesel dual-fuel engine

CFD investigation the combustion characteristic of ammonia in low-speed marine engine under different combustion modes

Hydrogen Enriched Ammonia Engines: Assessment of Hydrogen Concentration in the Fuel Feed from the Laminar Flame Speed Viewpoint

Combustion and emission characteristics of high-pressure ammonia direct injection marine dual-fuel engine

Feasibility study of hydrogen jet flame ignition of ammonia fuel in marine low speed engine

Evaluation of Ammonia Co-fuelling in Modern Four Stroke Engines

Theoretical investigation of the combustion performance of ammonia/hydrogen mixtures on a marine diesel engine

Exploration of environmentally friendly marine power technology -ammonia/diesel stratified injection

Ammonia energy fraction effect on the combustion and reduced NOX emission of ammonia/diesel dual fuel

Effect of ammonia/hydrogen blending and injection modes on combustion emission and performance of marine engine

Application of enhanced combustion strategies and optimized ignition timing for achieving high thermal efficiency and low N2O emissions of marine ammonia engine at full-load condition

Experimental and numerical analysis of engine characteristics of an ammonia-substituted dual-fuel CRDI diesel engine

Study on the impact mechanism of ammonia energy fraction on in-cylinder combustion and pollutant generation under wide operation conditions of medium-speed diesel engines

Optimization of Combustion Cycle Energy Efficiency and Exhaust Gas Emissions of Marine Dual-Fuel Engine by Intensifying Ammonia Injection