Abstract:The majority of environmental researchers are becoming increasingly concerned with the manufacture of inexpensive adsorbents for the detoxification of industrial effluents. To address one of the significant and well-known pollution issues with certain drains that act as hotspots and contribute to coastal pollution in Alexandria, this study aims to develop an economical, ecologically friendly sorbent. This study assessed the efficacy of a biomass-coated magnetic composite and a magnetic active adsorbent for the removal of two dyes from an industrially contaminated sewer using a wetland plant ( Phragmites australis ). Using magnetic biosorbent, the biosorption of Xylenol orange and Congo red ions from polluted drain discharge in Abu Qir Bay was evaluated in the current study. Using scanning electron microscopy imaging and Fourier transform infra-red analysis; the surface function and morphology of the nano-biosorbent were examined. At room temperature, the effects of initial dye concentration, pH, contact time, and nano-biosorbent concentration have all been investigated. The greatest percentages that nano-biosorbent can remove from Congo red and Xylenol orange are 97% and 47%, respectively. The removal of the initial Congo red concentration varied from 42 to 97%, while the removal of the initial Xylenol orange concentration varied from 30 to 47%. The adsorption capacity was shown to be strongly pH-dependent; capacity dose as pH value increased, with pH 10 being the ideal pH for Congo red and pH 6 being the ideal pH value for Xylenol orange. The adsorption capacity for Congo red varied between 0.96 and 3.36 and the adsorption capacity for Xylenol orange varied between 0.18 and 17.58. The removal capacity decreased from 3.36 to 0.96 mg/g when the biosorbent dosage was increased from 0.05 to 0.5 g/L for Congo red, in case of Xylenol orange, the removal capacity increased from 0.18 to 17.58 mg/g when the biosorbent dosage was increased from 0.05 to 0.5 g/L. The removal capacity of Congo red increases quickly with time and varied from 1.66 to 1.88 of contact time; while the removal capacity of Xylenol orange varied between 3.08 and 4.62 of contact time. For the dyes under study, kinetics and adsorption equilibrium were examined. Within 180 min, the equilibrium was attained because to the quick adsorption process. For Congo red and Xylenol orange, the highest adsorption capacities were 3.36 and 17.58 mg g −1 , respectively. The equilibrium data were assessed using a number of isotherm models, including Langmuir, Freundlich, BET, and Tempkin, while the kinetic data were examined using a variety of kinetic models, including pseudo-first- and pseudo-second-order equations. The pseudo-second-order equation provides the greatest accuracy for the kinetic data and Langmuir model is the closest fit for the equilibrium data.

Adsorption of Reactive Red 195 from aqueous medium using Lotus (Nelumbo nucifera) leaf powder chemically modified with dimethylamine: characterization, isotherms, kinetics, thermodynamics, and mechanism assessment

Removal of sulfonated azo Reactive Red 195 textile dye from liquid phase using surface-modified lychee (Litchi chinensis) peels with quaternary ammonium groups: Adsorption performance, regeneration, and mechanism

Adsorption and catalytic reduction of basic red 1 dye by nickel nanoparticles hydrogel: A study on kinetics, isotherm, and thermodynamics

Rapid Removal of Dyes by Carbonized Sludge: Process, Effects of Environmental Factors, and Mechanism

Development of novel adsorbent for removal of organic contaminant from polluted water: kinetic, isotherm and thermodynamic studies

Adsorption of Reactive Red 195 dye from industrial wastewater by dried soybean leaves modified with acetic acid

Acidified groundnut cake for enhanced bio adsorption of anionic textile dye Reactive Red 195

Lotus pollen-derived hierarchically porous carbons with exceptional adsorption performance toward Reactive Black 5: Isotherms, kinetics and thermodynamics investigations

Insight of Anionic Dyes Adsorption from Their Aqueous Solutions onto MgAl LDH/Lignin: Characterization and Isotherm Studies

Agro-based Adsorbents for Dye Removal from Aqueous Solutions: A Review

Kinetics, mechanism, isotherms, and design analysis on the removal of toxic dye from water using surface-modified agro-waste biomass

Rhodamine 6g Removal from Aqueous Solution with Coconut Shell-Derived Nanomagnetic Adsorbent Composite (Cs-Nmac): Isotherm and Kinetic Studies

Synthesis, Characterization, and Application of La‐CNT in the Adsorption of Aqueous Rhodamine B Dye Solutions

Hollow Polyaniline Microsphere/MnO2/Fe3O4 Nanocomposites in Adsorptive Removal of Toxic Dyes from Contaminated Water

Sustainable Bio-Based Adsorbents for Simultaneous and Efficient Removal of Hazardous Dyes from Aqueous Solutions

Utilization of aquatic biomass as biosorbent for sustainable production of high surface area, nano- microporous, for removing two dyes from wastewater

Removal of Methylene Blue from Aqueous Solutions Using Luffa Adsorbent Modified with Sodium Dodecyl Sulfate Anionic Surfactant

Dual Function of Modified Palm Leaf Sheath Fibers in Adsorbing Reactive Yellow 3 and Cr(VI) From Dyeing Wastewater

Waste to wealth: Facile activation of red mud waste and insights into industrial reactive dye removal from wastewater

Use of waste materials--Bottom Ash and De-Oiled Soya, as potential adsorbents for the removal of Amaranth from aqueous solutions

Synthesis of potential bio-adsorbent from Indian Neem leaves (Azadirachta indica) and its optimization for malachite green dye removal from industrial wastes using response surface methodology: kinetics, isotherms and thermodynamic studies