Abstract:A method to stabilize the resonance wavelength of a depletion-type silicon micro-ring resonator modulator during high-speed operation is described. The method utilizes the intrinsic defect-mediated photo-absorption of a silicon waveguide and results in a modulator chip fabrication process that is free of heterogeneous integration (for example using germanium), thus significantly reducing the complexity and cost of manufacture. Residual defects, present after p-n junction formation, are found to produce an adequate photocurrent for use as a feedback signal, while an integrated heater is used to compensate for thermal drift via closed-loop control. The photocurrent is measured by a source-meter, which simultaneously provides a DC bias to the integrated heater during high-speed operation. A drop-port or an integrated extrinsic detector is not needed. This feedback control method is experimentally demonstrated via a computer-aided proportional-integral-differential loop. The resonance locking is validated for 12.5 Gb/s intensity modulation in a back-to-back bit-error-rate measurement. The stabilization method described is not limited to a specific modulator design and is compatible with speeds greatly in excess of 12.5 Gb/s, in contrast to the bandwidth limitation of other stabilization methods that rely on intrinsic photo-carrier generation through non-linear processes such as two-photon-absorption. Further, the use of intrinsic defects present after standard fabrication insures that no excess loss is associated with this stabilization method.

Closed-Loop Control of Photonic Ring Resonators by Means of Photo-Thermal Plasmonic Sensors

Optical Sensors Based on Cascaded Micro-Ring Resonators with Thermo-Optical Tuning

Surface Plasmon Resonance Demodulation by Optical Ring-Down Cavity Technology

Thermal-optic Tuning Cascaded Double Ring Optical Sensor Based on Wavelength Interrogation

Non-invasive monitoring and control in silicon photonics by CMOS integrated electronics

Real-time imaging of standing-wave patterns in microresonators

Optothermal Control of the Raman Gain Enhanced Ringing in Microresonators

Thermo-Optical Tuning Cascaded Double Ring Sensor With Large Measurement Range

Nonlinear optical bistability in microring resonators for enhanced phase sensing

Double-Slot Hybrid Plasmonic Ring Resonator Used for Optical Sensors and Modulators

Wavelength stability in a hybrid photonic crystal laser through controlled nonlinear absorptive heating in the reflector

Enhancement from plasmonic-molecular coupling for mass transduction

An Integrated Photonic Gas Sensor Enhanced by Optimized Fano Effects in Coupled Microring Resonators With an Athermal Waveguide

Cancellation of photothermally induced instability in an optical resonator

Optimized hybrid plasmonic waveguide-based ring resonator for advanced refractive index sensing

Optimisation and artifacts of photothermal excitation of microresonators

Resonance control of a silicon micro-ring resonator modulator under high-speed operation using the intrinsic defect-mediated photocurrent

Direct 3D-printed ring-resonator photonic circuit on a dual core fiber tip for remote sensing applications

Optical Control and Tuning of Thermal-Piezoresistive Self-Sustained Oscillators

Surface-Plasmon-Polariton Laser Based on an Open-Cavity Fabry-Perot Resonator

Optical control of plasmonic heating effects using reversible photo-alignment of nematic liquid crystals