Abstract:For the traditional preparation method, it is challenging to fabricate a supported nickel catalyst with fine size at high loading. In this work, a group of La-modified mesostructured cellular foam (MCF)-derived nickel phyllosilicates was designed and synthetized by a hydrothermal method followed by an impregnation-modification of La2O3, whose Ni contents varied from 25.3 to 32.2 wt %. Both the special property of phyllosilicate and the addition of a La2O3 modifier played significant roles in achieving high Ni dispersion and excellent catalytic performance. The formed nickel phyllosilicate was beneficial to obtain small Ni nanoparticles (<5 nm) due to its strong metal-support interaction and high specific surface area; the addition of the La2O3 modifier could further reduce the Ni particle size and decrease the reduction difficulty of the fabricated samples. On the contrary, a large Ni particle size of 13.0 nm was observed on the impregnated Ni/MCF (N/M-Im) catalyst with a Ni content of 31.7 wt %. As a result, the nickel phyllosilicate catalyst showed higher catalytic activity than the impregnated one, and the La modifier could further improve the catalytic activity especially at low temperature (<400 °C). Among all catalysts, the modified phyllosilicate catalyst N/M-P-32-5L with 180 °C-32 h-hydrothermal treatment and La2O3 content of 5 wt % was the best owing to its small-sized Ni particles, high H2 and CO2 chemisorption capacity, large turnover frequency (TOF) value, and low activation energy of 69.83 kJ mol-1. In addition, the intermediates of formate and CO were detected through in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) analysis. In a 100 h-lifetime test under harsh conditions and 600 °C-steam treatment, N/M-P-32-5L showed both high sintering resistance of Ni particles and high thermal stability without the collapse of pores as well as decrease of catalytic activity, which was attributed to the special physical and chemical properties of MCF-derived nickel phyllosilicate, strong metal-support interaction over the catalyst, and the promotion of the La2O3 modifier.

Interface-controlled synthesis of nickel phyllosilicate for efficient CO 2 hydrogenation to methane: Breaking limitation of the conventional silica-surface-controlled synthesis

Rapid construction of nickel phyllosilicate with ultrathin layers and high performance for CO2 methanation

Facile synthesis of Ni-phyllosilicate assisted by polyacrylamide at room temperature for CO 2 hydrogenation to methane

Simultaneously quantitative and qualitative regulation of active sites of Ni-phyllosilicate for enhanced CO 2 hydrogenation to methane

Highly Efficient Ni-Phyllosilicate Catalyst with Surface and Interface Confinement for CO<sub>2</sub> and CO Methanation

Simultaneously Quantitative and Qualitative Regulation of Active Sites of Ni-Phyllosilicate for Enhanced Co2 Hydrogenation to Methane

Nickel Phyllosilicate Derived Ni/Sio2 Catalysts For Co2 Methanation: Identifying Effect Of Silanol Group Concentration

Synthesis of Ni-phyllosilicate assisted by fluoroboric acid for CO 2 methanation

Ni<sub>12</sub>P<sub>5</sub> Confined in Mesoporous SiO<sub>2</sub> with Near-Unity CO Selectivity and Enhanced Catalytic Activity for CO<sub>2</sub> Hydrogenation

Tunable Colloidal Ni Nanoparticles Confined and Redistributed in Mesoporous Silica for CO2 Methanation

Silica-nickel Catalyst Interfaces Promote Highly Efficient CO2 Electroreduction to CO with a Wide Potential Range

Efficient Utilization of Silanol Group in Rice Husk to Promote the Synthesis of Ni-phyllosilicate for CO2 Methanation

Efficient utilization of silanol group in rice husk to promote the synthesis of Ni-phyllosilicate for CO 2 methanation

Regulation of Metal Utilization Ratio and Active Sites of Nickel Phyllosilicates for Enhanced Co2 Methanation

Enhanced stability of Ni/SiO2 catalyst for CO2 methanation: Derived from nickel phyllosilicate with strong metal-support interactions

Revealing the Anti-Sintering Phenomenon on Silica-Supported Nickel Catalysts During CO2 Hydrogenation

Glycerol-assisted Dynamic Hydrothermal Synthesis of Nickel Phyllosilicate for Enhanced CO2 Methanation: Synergistic Effect of Stirring and Viscous Solvent

Lanthanum-Modified MCF-Derived Nickel Phyllosilicate Catalyst for Enhanced CO2 Methanation: A Comprehensive Study

Ensemble Effect of the Nickel-Silica Interface Promotes the Water-Gas Shift Reaction

The construction of nanotubular Ni-Mg phyllosilicate solid solution catalyst for boosting CO 2 catalytic conversion: Identifying the species variations and interactions

Clarification of Active Sites at Interfaces Between Silica Support and Nickel Active Components for Carbon Monoxide Methanation