Abstract:BACKGROUND The early clinical management of patients with major trauma still represents a challenge. To clinically evaluate the full extent of a patient's injuries is difficult, especially when the patient is unconscious. Before December 2002, trauma patients admitted to our emergency room (ER) underwent a diagnostic protocol including physical examination, conventional radiography (CR), sonography and further procedures if necessary. After the installation of a MSCT scanner, all trauma patients underwent the "MSCT protocol" immediately after admission. The aim of the study was to compare the "MSCT-protocol" as it is performed at our institution, with the "Pre-MSCT-protocol". METHODS We compared 185 patients undergoing the "Pre MSCT-protocol" with 185 patients undergoing "MSCT protocol". We evaluated the efficacy, speed and accuracy of the "MSCT protocol" using several variables. Time periods from admission to the ER to admission to the intensive care unit were compared as well as outcome parameters such as length of ICU stay, ventilation period and rates of organ. Dichotomous data were analyzed by Chi-square analysis; continuous data were analyzed by Student's t test. Any values of p < 0.05 were considered significant for any test. RESULTS No significant differences were found regarding demographic data. The full extent of injuries was definitively diagnosed after 12 +/- 9 minutes in 92.4% of the "MSCT protocol" cohort. In only 76.2% of "Pre-MSCT protocol" cohort definitive diagnosis was possible after 41 +/- 27 minutes. Total ER time was 104 +/- 21 minutes with the "Pre-MSCT protocol" and 70 +/- 17 minutes with "MSCT protocol" (p < 0.05). "Pre-MSCT protocol" patients had a significantly longer ICU stay than "MSCT protocol" patients (p < 0.05). "MSCT protocol" patients had significantly fewer ventilation days (14.3 vs. 10.9 days). Furthermore, rates of organ failure were lower in patients undergoing the "MSCT protocol". CONCLUSION We could demonstrate that immediate MSCT in patients with blunt major trauma leads to more accurate and faster diagnosis, and reduction of early clinical time intervals. We also observed a reduction in ventilation, ICU, and hospital days, and in organ failure rates, though this might have been partly due to small differences in case mix. The "MSCT protocol" algorithm seems to be safe and effective.

Convective Heat Transfer and Infrared Thermography

Emergency room management of patients with blunt major trauma: evaluation of the multislice computed tomography protocol exemplified by an urban trauma center.

Infrared thermography with non-uniform heat flux boundary conditions on the rotor endwall of an axial turbine

Infrared Thermography to Measure Heat Transfer of a Heated Curved Thin Sheet

Measuring time-resolved heat transfer fluctuations on a heated-thin foil in a turbulent channel airflow

Infrared thermography techniques for boundary layer state visualisation

Evaluation of Heat Conduction and Visualization of Heat Flux in a Plate Making Use of Heat Transfer Experiments

Study on the Measurement of Temperature Field Using Laser Holographic Interferometry

A Fundamental-Study of the Heat-Transfer and Flow Situation Around Spacers (A Single Row of Several Cylindrical Rods in Cross Flow)

Experimental investigation of conduction heat transfer in a rotary drum using infrared thermography

Experimental Identification of Thermophysical Properties in Heterogeneous Materials with Integral Transformation of Temperature Measurements from Infrared Thermography

A Method for Researching Natural Convection Heat Transfer from a Non-Isothermal Vertical Plate by Infra-Red Thermovision

Heat transfer and air flow near a pair of circular cylinders

Infrared thermometry in high temperature materials processing: influence of liquid water and steam

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Quantification of Heat Transfer Coefficient in Transient Liquid Crystal Experiments

Thermographic analysis of turbulent non-isothermal water boundary layer

Infra-red thermographic inversion in ST40

The use of infrared thermography for materials characterization

Mid-infrared spectroscopic thermotransmittance measurements in dielectric materials for thermal imaging

Heat diffusion imaging: In-plane thermal conductivity measurement of thin films in a broad temperature range

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Determination of Heat Transfer Coefficient