Abstract:A different to conventional monitoring systems sensor equipped tools give the possibility to gain information about the process status directly from the contact zone between tool and component to be machined. For example this can be realized by the integration of small temperature sensors into grinding wheels. The transmitting of the process data is performed by a telemetric unit attached to the grinding wheel's core. In this paper, the development of a new thin film thermocouple sensor concept is described. The unique feature of this sensor is the continuous contacting of the thermocouple through the grinding process inherent wear which leads to smearing of the thermoelectric layers and thus forming the measuring junction of a thermocouple. The system was used in OD grinding processes aiming to detect grinding burn and process instabilities. By reducing the volume of the sensors a fast response and high time resolution can be obtained. By this way, observance of the key parameters of the practical operation as closely as possible to the cutting area is enabled and so observance of process efficiency and tool status independent from workpiece machining conditions can be realized. All sensors used are thermocouples of type K, a combination of Chromel (NiCr) and Alumel (NiAlMnSi) material. The maximum temperature to be measured by this sensor is about 1350 °C, which ensures the applicability in the grinding process. Telemetry components to amplify and send the thermovoltage signals are adjusted to this type of thermocouple. The ability of the set‐up to detect thermal influences was demonstrated in grinding processes with a continuously increasing specific material removal rate. The approach serves to measure temperatures between fast sliding surfaces in harsh environments (fluids, high pressure, heat), similar to the grinding process. Therefore their application is not limited to tools but also applicable for other rotating components such as bearings, gears and shafts in powertrains. A new thin film thermocouple sensor concept, usable for grinding tool integration, is described in this paper. The unique feature of this sensor is the continuous contacting of the thermocouple through the grinding process inherent wear which leads to smearing of the thermoelectric layers and thus forming the measuring junction of a thermocouple.

Multifunctional thin film sensor system as monitoring system in production

Development of thin-film based sensors for temperature and tool wear monitoring during machining

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Development, Characterisation and High-Temperature Suitability of Thin-Film Strain Gauges Directly Deposited with a New Sputter Coating System

Highly Precise Multifunctional Thermal Management-Based Flexible Sensing Sheets

Monitoring of Machining Processes Using Sensor Equipped Tools

Laser-Structured Thin Film Sensor Technology for Sliding Bearings in Internal Combustion Engines

Softsensors: key component of property control in forming technology

Thin-Film-Based Multifunctional System for Optical Detection and Thermal Treatment of Biological Samples

A thin-film temperature sensor based on a flexible electrode and substrate

Advances in Thin Film Sensor Technologies for Engine Applications

Real-Time Two-Dimensional Mapping of Relative Local Surface Temperatures with a Thin-Film Sensor Array

Development of multi-functional sensors in thick-film and thin-film technology

Design of a Multi-sensor Monitoring System for Additive Manufacturing Process

Application-specific sensor systems based on CMOS chemical microsensors

Integration Technology with Thin Films Co-Fabricated in Laminated Composite Structures for Defect Detection and Damage Monitoring

Large-Area Thickness Measurement of Transparent Films Based on a Multichannel Spectral Interference Sensor

Fabricating biomedical sensors with thin-film technology

Flexible Ceramic Film Sensors for Free-Form Devices

Hybrid Printing of Silver-Based Inks for Application in Flexible Printed Sensors

Development of a sensor for liquid film thickness measurements during annular flow in microchannels