Abstract:Superfine powdered activated carbon (S-PAC) is an adsorbent material with particle size between roughly 0.1-1 μm. This is about an order of magnitude smaller than conventional powdered activated carbon (PAC), typically 10-50 μm. S-PAC has been shown to outperform PAC for adsorption of various drinking water contaminants. However, variation in S-PAC production methods and limited material characterization in prior studies lead to questions of how S-PAC characteristics deviate from that of its parent PAC. In this study, a wet mill filled with 0.3-0.5 mm yttrium-stabilized zirconium oxide grinding beads was used to produce S-PAC from seven commercially available activated carbons of various source materials, including two coal types, coconut shell, and wood. Particle sizes were varied by changing the milling time, keeping mill power, batch volume, and recirculation rate constant. As expected, mean particle size decreased with longer milling. A lignite coal-based carbon had the smallest mean particle diameter at 169 nm, while the wood-based carbon had the largest at 440 nm. The wood and coconut-shell based carbons had the highest resistance to milling. Specific surface area and pore volume distributions were generally unchanged with increased milling time. Changes in the point of zero charge (pH(PZC)) and oxygen content of the milled carbons were found to correlate with an increasing specific external surface area. However, the isoelectric point (pH(IEP)), which measures only external surfaces, was unchanged with milling and also much lower in value than pH(PZC). It is likely that the outer surface is easily oxidized while internal surfaces remain largely unchanged, which results in a lower average pH as measured by pH(PZC).

Relationship between chemical and physical surface properties of activated carbon

Research on Surface Treatment of Carbon Fiber and the Conductive Properties of Paper

Effect of bead milling on chemical and physical characteristics of activated carbons pulverized to superfine sizes

Preparation of a pitch-based activated carbon with a high specific surface area

SURFACE MODIFICATIONS OF ACTIVATED CARBON AND ITS IMPACT ON APPLICATION

Self-flocculated Powdered Activated Carbon with Different Oxidation Methods and Their Influence on Adsorption Behavior

Hierarchical Pore Structure of Activated Carbon Fabricated by CO2/microwave for Volatile Organic Compounds Adsorption

Effects of surface modification on the porous structure and thermal-electric energy conversion of activated carbon

The Significance of Physical Factors on the Adsorption of Polyaromatic Compounds by Activated Carbons

Coexistence of reactive functional groups at the interface of a powdered activated amorphous carbon: a molecular view

Physicochemical Properties of Carbons Prepared from Pecan Shell by Phosphoric Acid Activation

Using Powdered Activated Carbon: A Critical Review

The Correlation Between Structural Characteristics of Activated Carbons and Their Adsorption of Organic Solutes from Aqueous Solutions

Effects of Chemical Modification of Petroleum Cokes on the Properties of the Resulting Activated Carbon

Preparation, characterization and adsorption performance of high surface area biomass-based activated carbons

Investigation on the surface properties of the carbon nanotubes before and after the adsorption of polyacrylic acid

Physical and chemical properties of carbons synthesized from xylan, cellulose, and Kraft lignin by H3PO4 activation

Effect Of The Surface Chemistry Of Activated Carbon On Its Electrochemical Properties In Electric Double Layer Capacitors

Adsorption Characteristics of Powdered Activated Carbon to Dimethyl Sulfide

Adsorption of Methylene Blue and Phenol by Wood Waste Derived Activated Carbon

Surface Chemical Functional Groups Modification of Porous Carbon