Abstract:In order to further improve the properties of the A356 (Al–7Si–0.3Mg) alloy, which is widely used due to its excellent properties, the effect of alloying different elements has been studied. Recently, the effect of rare earth elements on a-Al grain size and Si morphology, which play a fundamental role in determining the mechanical properties, has attracted attention and studies have focused on this area. Therefore, the effects of the addition of rare earth elements erbium (Er) and europium (Eu) to the A356 alloy at different ratios on the microstructure and mechanical properties of the as-cast and T6 heat-treated condition are investigated in this paper. Grain refinement with the addition of Er and grain coarsening with the addition of Eu were observed. The average grain size decreased by 32% and became 643 μm. On the other hand, the grain size coarsened 36% (873 μm) with the addition of 0.3 Eu to 0.3 Er wt%. The unalloyed as-cast eutectic Si length was 12.0 μm and the Si aspect ratio was 9.6. The acicular long eutectic Si phases had been modified and started to form spherical with T6 state. Although the modification effect on the eutectic Si increases with the increase in the amount of Er, the modification of Eu eutectic Si is much more effective. The most effective eutectic Si modification was achieved by the addition of 0.1 Er + 0.3 Eu wt% with heat treatment when the eutectic Si refined by 80%. The best mechanical properties were obtained with the addition of 0.1 Er with T6 state. In microstructure and fracture surface SEM analysis results, the number and size of intermetallic phases increased with the addition of alloying element. Although these acicular intermetallic phases are reduced in size by heat treatment, they were not fully spherical.

N=4 Gauge Theories in 3D, Hilbert Series, Mirror Symmetry and Enhanced Global Symmetries

Effects of Er Additions on the Microstructure, Mechanical Properties, and Electrical Conductivity of the Al‐0.4Fe‐0.05Si Alloy

Microstructure refinement and enhanced tensile properties of Al-11Mg2Si alloy modified by erbium

Effect of Ti Addition and Electric Field on Microstructure and Mechanical Properties of the Al-Si-Fe Hypereutectic Alloy

Effect of Minor Er Additions on the Microstructures and Mechanical Properties of Cast Al-Cu-Mg-Ag Alloys

Microstructural Evolution and Mechanical Properties of Al0.3CoCrFeNiSix. High-Entropy Alloys Containing Coherent Nanometer-Scaled Precipitates

Effect of Rare Earth Elements Erbium and Europium Addition on Microstructure and Mechanical Properties of A356 (Al–7Si–0.3Mg) Alloy

Effects of rare earth Er additions on microstructure development and mechanical properties of die-cast ADC12 aluminum alloy

Effects of addition of Er and Zr on microstructure and mechanical properties of Al–Cu–Mn–Si–Mg alloy

Effect of Rare Earth Dy (dysprosium) on the Microstructures and Mechanical Properties of Hypereutectic Al–Si Alloy

Unveiling the Precipitation Behavior and Mechanical Properties in G-phase Strengthened CrFe2Ni2Ti0.2Six Multi-Principal Element Alloys

Effect of Ti on Microstructure and Mechanical Properties of Die-Cast Al-Mg-Zn-Si Alloy

Effects of AlCrFeNiTi HEA Addition on Microstructure and Mechanical Properties of Hypereutectic Al–20Si Alloy

Enhanced Strength–Corrosion Synergy of 6061Al Casting Alloy Through Erbium Addition

Effects of Zr+Er and Zr+Y on Microstructure and Tensile Properties of Al-Mg-Si-Cu-Mn-Cr Alloys

Influence of Erbium and Thermal Treatments on the Microstructure and Hardness of Al-Mg-Si Alloy

Influence of Er-doping on the microstructure and properties of β-Ti high temperature shape memory alloy

Microstructure control and performance evolution of hypereutectic Al–20Mg2Si alloy by novel Al–Ca–Sb master alloy

Influences of Ti additions on the microstructure and tensile properties of AlCoCrFeNi2.1 eutectic high entropy alloy

Microstructure and mechanical properties of Si micro-alloyed (Ti28Zr40Al20Nb12)100-xSix (x=0, 0.1, 0.2, 0.5) high entropy alloys

Effect of the Solid Solution and Aging Treatment on the Mechanical Properties and Microstructure of a Novel Al-Mg-Si Alloy