Abstract:B-Pillars are specifically designed to absorb substantial energy with a minimum amount of deformation to limit its intrusion in the passenger compartment during an event of side impact. In this paper, the B-pillar has been developed using composite materials, with the main objective is to improve crashworthiness performance at a lesser weight, as a replacement for steel. The three-point bending test simulations of the composite B-pillar model were modelled, which applied various parameters of materials, number of ply and additional reinforcement. The composite B-pillar design parameter that scored the highest performance to weight ratio in the numerical simulation was then fabricated using vacuum bagging method. Subsequently, the B-pillar was tested under three-point bending experimental work. The force and central displacement results were compared to simulation data and a good agreement was obtained, where B-pillar made of carbon fibre reinforced polymer (CFRP) performed better than glass fibre reinforced polymer (GFRP). The simulation and experimental results indicated errors ranging between 6 and 15%. With the additional reinforcement at the critical area, the energy absorption of CFRP B-pillar was considerably improved by 18%. The weight of the fabricated composite B-pillar was 58% lighter compared to the original steel B-pillar. These results confirmed that the novel composite material holds a high strength, and has lightweight potential to substitute steel as car B-pillar material. The original version of this article supplied to AIP Publishing contained a typographical error in the title. The original title appeared as, “Finite element modelling and analysis of computer B-pillar,” whereas “computer” should have appeared as “composite.” This error has been addressed and corrected in the article republished on 28 February 2019.

Bending Performance and Reinforcement of Rocker Panel Components with Unidirectional Carbon Fiber Composite

Strength, Stiffness, and Panel Peeling Strength of Carbon Fiber-Reinforced Composite Sandwich Structures with Aluminum Honeycomb Cores for Vehicle Body

Experimental and numerical studies on bending characteristics of woven CFRP reinforced aluminum thin-walled automotive structures

Design and optimization of composite sub-stiffened panels

Flexural Performance of Steel–FRP Composites for Automotive Applications

Research on Flexural Performance of Curved Carbon Fiber Laminate Composites

Study on automobile body performance of honeycomb sandwich composite material

Development of A Carbon Fiber Reinforced Composite Chassis Longitudinal Arm

Three-point Bending Performance of a New Aluminum Foam Composite Structure

Shear and Bending Performance of Carbon Fiber Composite Sandwich Panels with Pyramidal Truss Cores

Evaluation of the mechanical properties and deformability of metal-based composite sheets made of thin stainless-steel sheets and carbon fiber reinforced plastics

Finite element modelling and analysis of composite B-pillar

Bending Performance of Carbon Fiber–reinforced Polymers/aluminum Sandwich Structure with Different Forming Process and Analysis of Failure Mode

Enhancement of Tensile Strength of Embedded Parts in Carbon Fiber-Reinforced Plastic/Aluminum Honeycomb Sandwich Structures for Vehicle

Introducing Composite Lattice Core Sandwich Structure As an Alternative Proposal for Engine Hood

Study on mechanical properties of carbon fiber honeycomb curved sandwich structure and its application in engine hood

Light-weight sandwich panel honeycomb core with hybrid carbon-glass fiber composite skin for electric vehicle application

Composite Hat Structure Design for Vehicle Safety: Potential Application to B-Pillar and Door Intrusion Beam

Bending Behaviors of Carbon Fiber Composite Honeycomb Cores with Various In-Plane Stiffness

Flexural property study of multiaxial fiber reinforced polymer sandwich panels with pultruded profile cores

Parametric design and modeling method of CFRP laminated components applicable for multi-material vehicle body development