Abstract:Data acquisition systems are required to condition the low-level analog signals from various sensors and to convert them into digital format in order to facilitate downstream processing. Distributed DAQ systems are commonly used in SONAR systems, as a large number of acoustic sensors are used in big platforms and the sensors are physically distributed. The data collected by the distributed DAQ systems are transmitted to a central processing system in real-time where further processing of the data is done. The operating environment of the underwater system can impose severe restrictions on the design of the DAQ system. This paper presents a hardware-software co-design based approach to implementing a resource-efficient FPGA-based distributed DAQ system. Here, the functionality of deterministic data transmission through Ethernet is implemented using RTL modules, and remote health monitoring and configuration control functionalities with TCP/IP stack support are implemented in a soft-processor inside FPGA. To reduce the number of external cables and the FPGA resource utilization, a single Ethernet MAC is shared between processor and RTL modules using AXI switches. Synchronized sampling of sensors is an important requirement in distributed DAQ systems. In this paper, synchronization is achieved by implementing the IEEE1588 precision time protocol in FPGA. By implementing the timestamping of the PTP messages at the RGMII interface, synchronization accuracy close to 300ns was achieved. The implementation was done on Artix7 FPGA from Xilinx with a resource utilization of 36K LUTs and 43K flip-flops. MicroBlaze soft-processor was used with 100 MHz clock and the Synchronization Timer was generated using a 200 MHz clock.

DESIGN AND IMPLEMENTATION OF CONTROL SYSTEM 6-UPS MEDICAL ROBOT BASED ON FPGA

Design of VxWorks-based High-performance Embedded Control Platform

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

Multi-axis motion control system based on DSP and FPGA

FPGA-based Controller for a Mobile Robot

Design and Implementation of FPGA Based High-Speed Bus for Control System

Design of humanoid robot control system based on DSP and FPGA

Design of Multi-serial Communication for Flight Controlling Computer Based on FPGA

The Dsp Implementation Of Rt Control Of 6-Dof Parallel Robot Based On Rcp

Embedded FPGA-based Motion Planning and Control of a Dual-arm Car-like Robot

The Design of Control System Based on ARM and High-speed Pulse Generator

FPGA-based Gait Control System for Passive Bipedal Robot.

Multi-axis motion controller for robotic applications implemented on an FPGA

Optimal fault resilient autonomous quadcopter control based on dynamic partial reconfigurable FPGA

Development of embedded fuzzy control using reconfigurable FPGA technology

FPGA Design Methodology for Industrial Control Systems—A Review

A Hardware-Software Co-design based Approach for Development of a Distributed DAQ System using FPGA

A Survey of FPGA-Based Robotic Computing

Using advanced FPGA SoC technologies for the design of industrial control applications

RCP and RT Control of 6-DOF Parallel Robot.

Variable Frequency Driver System of Asynchronous Motor Based on FPGA