Abstract:Attosecond science is one of the driving forces for developing the femtosecond amplifiers of high average power and ultrashort pulse duration. In this work, the regenerative amplification is studied experimentally and theoretically based on Yb:CaYAlO4 crystal for the practical needs of high-repetition-rate attosecond light sources. In the theoretical study, a mode-tunable regenerative cavity with good thermal stability is designed based on the thermal lens calculations of Yb:CaYAlO4 crystal; the amplified output energy and spectra of π and σ polarization of the crystal are calculated. In the experiment, the π-axis of Yb:CaYAlO4 crystal is parallel to the laser polarization, and the laser amplifier emits 1.61 mJ pulses with average power 16.1 W. Notably, the dip of the π-polarization emission spectrum near 1025.1 nm compensates for the gain narrowing of the seed laser during amplification. Thus, the center wavelength and the spectral full width at a half maximum of the amplified laser are 1030 nm and 16 nm respectively. Using a grating-pair for compression, 149 fs pulses with peak power 9.5 GW are obtained. In comparison, the σ-polarization emission spectrum of Yb:CaYAlO4 crystal is relatively flat in a range from 1000 to 1050 nm, but with a larger gain cross-section. When the laser polarization is parallel to the σ-axis of Yb:CaYAlO4 crystal, 2.87 mJ pulses at 10 kHz repetition rate are achieved, with an average power of 28.7 W. In this case, the center wavelength and the spectral full width at half maximum of the amplified laser are 1037 nm and 11 nm respectively. Using a grating-pair for compression, 178 fs pulses with peak power of 14.2 GW are obtained. The beam quality factor measured is 1.09 along the x-axis of the amplified laser and 1.17 along the y-axis. To the best of our knowledge, this is the highest average power and the maximum pulse energy obtained from the Yb:CaYAlO4 amplifier. For applications in high-repetition-rate attosecond light sources, terahertz generation and optical parametric amplification, subsequent laser outputs with average power 200 W, pulse energy 20 mJ and pulse duration less than 200 fs are expected to be achieved by adding two stages of traveling-wave amplification.

Optical rectification of a 100 W average power mode-locked thin-disk oscillator

Single-cycle, 643-mW average power THz source based on tilted pulse front in lithium niobate

Single-cycle, MHz repetition rate THz source with 66 mW of average power

High-power 55-fs Yb:YAG thin-disk oscillator at 200 MHz repetition rate

High-power intracavity single-cycle THz pulse generation using thin lithium niobate

High-average-power, 2-μm femtosecond optical parametric oscillator synchronously pumped by a thin-disk, mode-locked laser.

Near-optimal intense and powerful terahertz source by optical rectification in lithium niobate crystal

High-field THz source centered at 2.6 THz

High-efficiency 100-W Kerr-lens mode-locked Yb:YAG thin-disk oscillator

Ultrafast Yb:YAG laser oscillator with gigahertz repetition rate

Directly diode-pumped, Kerr-lens mode-locked, few-cycle Cr:ZnSe oscillator

High-power single-cycle THz emission from large-area photoconductive emitters at 400 kHz

Ultrafast thin-disk laser with 80 μJ pulse energy and 242 W of average power

GHz repetition rate, sub-100-fs Ho:CALGO laser at 2.1 um with watt-level average power

High average power amplification of femtosecond pulses based on the Yb:CaYAlO4 crystal

400 kHz repetition rate THz-TDS with 24 mW of average power driven by a compact industrial Yb-laser

Amplification-free GW-level, 150 W, 14 MHz, and 8 fs, thin-disk laser oscillator

Efficient long-wave infrared ZGP optical parametric oscillator pumped by a diode-pumped AO Q-switched Ho:YAG laser

An efficient high-power femtosecond laser based on periodic-layered-Kerr media nonlinear compression and a Yb:YAG regenerative amplifier

Yb:CaYAlO<sub>4</sub> Regenerative Amplifier

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm