Abstract:Recently, various technological light sources have appeared on the market. As a result, it is extremely important to evaluate the characteristics of the available lamps and the impact they may have on the power grid. This article presents regulations and standards for power quality, including higher current and voltage harmonics, and analyzes three selected light-emitting diode lamps. The purpose of the study was to analyze the impact of LED lighting systems on the power quality (PQ) of the electric grid. The results of measurements of parameters determining the power quality of the electricity consumed by modern LED light sources used for room lighting are presented. Commercially available lamps and low-power power supplies (25 to 35 W) with an output current of 350 mA were used for the study. The current waveforms of selected lamps during their connection to the power grid, the results of harmonic emission tests, as well as the effect of increasing the load of selected DC power supplies (drivers) on THD, power factor (PF), and their efficiency are presented. The significant negative impact of power supply circuits in compact LED lamps on the power quality parameters of lighting circuits was demonstrated. The tested lamps significantly exceed the permissible limits of harmonics and THD. Test results have shown that LED lamps show significant savings in electricity consumption, but they behave as nonlinear loads. They generate high-frequency current harmonics, which can lead to degradation of power quality in the distribution network. Therefore, if the primary concern for the user is power quality rather than power savings, traditional incandescent lamps would be a much better choice. When using switched-mode power supplies, attention should be paid to their load rating. You should avoid using power supplies in the lower ranges of permissible load capacity. A more heavily loaded power supply has better performance due to power quality and efficiency.

Research on the Flicker Effect in Modern Light Sources Powered by an Electrical Network

Research on Load Characteristics of Energy-saving Lamp and LED Lamp

Comparison of Detection and Suppression Methods for Voltage Fluctuation and Flicker

Effect of LED Lighting on Selected Quality Parameters of Electricity

A Capacitorless and Low‐Optical‐Flicker AC Direct LED Driving IC and System Applied to Street Lighting

Wavelet entropy and its application for flicker contribution evaluation

Issues and Technology Assessment on Power Quality Part 4:Measurement and Analysis of Voltage Fluctuation and Flicker

Measurement Methods and Impact Factors for Light Output Fluctuation of Light Sources

Introduction and Analysis of Relative Standards of Voltage Flicker

Review on Methods for Voltage Fluctuation and Flicker Source Location

Flicker Measurements at an Industrial Power Network with Wind Turbines

IEC Flickermeter Measurement Results for Distorted Modulating Signal while Supplied with Distorted Voltage

An Evaluation Method for Lighting Flicker Based on Frequency Spectrum Analysis

A Flicker Measuring Method Based on Improved Sine Interpolation

Research on algorithms of flicker detection and calculation methods in power system

Voltage flicker measurement method using improved Teager-Kaiser energy operator based on Nuttall window spectral correction

Statistical Analyses of <formula Formulatype="inline"> <tex Notation="TeX">${\rm P}_{\rm St}$</tex></formula> and <formula Formulatype="inline"> <tex Notation="TeX">$\Delta{\rm V}_{10}$</tex></formula> Recorded at Electric Arc Furnaces

Experimental and numerical study of impact of voltage fluctuate, flicker and power factor wave electric generator to local distribution

Statistical Analyses Of P-St And Delta V-10 Recorded At Electric Arc Furnaces

A Novel Method Based on Wavelet Threshold De-Noising Technology and Prony Analysis for Flicker Measurement

Electric Arc Furnace Voltage Flicker Analysis and Prediction.