Abstract:We proposed a novel kind of absolute capacitive grating displacement measuring system with both high accuracy and long range in a previous article. The measuring system includes both a MOVER and a STATOR, the contact surfaces of which are coated by a thin layer of dielectric film with a low friction coefficient and high hardness. The measuring system works in contact mode to minimize the gap changes. This paper presents a theoretical analysis of the influence of some factors, including fabrication errors, installation errors, and environment disturbance, on measurement signals. The measuring signal model was modified according to the analysis. The signal processing methods were investigated to improve the signal sensitivity and signal-to-noise ratio (SNR). The displacement calculation model shows that the design of orthogonal signals can solve the dead-zone problem. Absolute displacement was obtained by a simple method using two coarse signals and highly accurate displacement was further obtained while using two fine signals with the help of absolute information. According to the displacement calculation model and error analysis, the error in fine calculation functions mainly determines the model's accuracy and is locally affected by coarse calculation functions. It was also determined that amplitude differences, non-orthogonality, and signal offsets are not related to the accuracy of the displacement calculation model. The experiments were carried out to confirm the abovementioned theoretical analysis. The experimental results show that the displacement resolution and error in the displacement calculation model reach ±4.8 nm and ±34 nm, respectively, in the displacement range of 5 mm. The experiments and the theoretical analyses both indicate that our proposed measuring system has great potential for achieving an accuracy of tens of nanometers and a range of hundreds of millimeters.

Design of High Precision Capacitance Displacement Sensor

A Planar Capacitive Sensor for 2D Long-Range Displacement Measurement

Research of Key Technology for High Precision Capacitive Displacement Sensor

Design and realization of a capacitive sensor measurement system

Simulation Analysis on Characteristics of a Planar Capacitive Sensor for Large Scale Measurement

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

A Planar Capacitive Sensor for Large Scale Measurement

New Contactless Conductivity Detection (CCD) Sensor for Fluid Conductivity Measurement

A Contactless Conductivity Sensor Based on Capacitively Coupled Principle

Design of Capacitively Coupled Contactless Conductivity Detection Sensor

A High-precision Displacement Measuring System in SPC

Digital Capacitance Measurement System Based on FPGA

New Small Capacitance Measuring Circuit for Capacitance Sensor

Design of capacitive sensor for both displacement and angle measurement

The Appliance of Duffing Chaotic Detection System in Displacement Measurement of Capacitance Sensor

Error Analysis and Modeling for an Absolute Capacitive Displacement Measuring System with High Accuracy and Long Range.

Design and analysis of an eddy current displacement sensor with extended linear range

High-precision micro-displacement sensor based on tunnel magneto-resistance effect

A Novel Coplanar Capacitive Micro-Displacement Sensor Combining Microfluidic Channels for Bridge Health Monitoring

Front-end Design of High Precision Displacement Sensor Based on Linear Array CCD

A Flexible Capacitive Tactile Sensor Array with High Scanning Speed for Distributed Contact Force Measurements