Effect of M (M = Fe, Co, Ni, Cu, Ce) loaded on blast furnace slag and its application in low‐temperature NH3‐SCR

Lei Zhang,Yuzhen Han,Hao Shu,Lei Zhang,Zhikun Han,Xueying Yang,Ya Chen
DOI: https://doi.org/10.1002/jctb.7298
IF: 3.709
2022-12-15
Journal of Chemical Technology and Biotechnology
Abstract:In order to control NOx in low‐temperature flue gases emitted from non‐power industries and to reduce the preparation cost of denitration catalysts. this study uses inexpensive blast furnace slag as raw material to prepare denitration catalysts. After cooling, drying and grinding, the blast furnace slag becomes a powder with considerable fineness and meets the requirements of activity index, which is called GGBS (ground granulated blast furnace slag). Using GGBS as denitration catalyst carrier, and the active components M (M = Fe, Co, Ni, Cu and Ce) is loaded on Mn‐based GGBS catalyst by impregnation method. The effect of different active components on the denitration performance and sulphur resistance of Mn‐based GGBS catalysts is investigated. The results show that Mn‐Ce/GGBS catalyst has better denitration performance and sulphur resistance. Mn‐Ce/GGBS catalyst has a significant denitration performance when load ratio is 2:1. The active component Ce improves the denitration performance of the catalyst, reduces catalyst sulphur poisoning and extends the life of the catalyst. The SO2 in the flue gas increases the acid sites on the catalyst surface and improves catalyst activity. The larger the ratio of Mn4+/Mn3+, Ce4+/Ce3+ and Oα/Oβ, the stronger the catalyst activity and the better the denitration performance. This article is protected by copyright. All rights reserved.
engineering, chemical,biotechnology & applied microbiology, environmental,chemistry, multidisciplinary
What problem does this paper attempt to address?