Abstract:In consolidation of AlON, the extensive decomposition of AlON into α-Al2O3 and AlN during sintering is one of the major reasons that significantly retard its densification process. To accelerate densification of AlON, an ultra-low concentration of La2O3 (0.03 wt%) and Y2O3 (0.02-0.04 wt%) was co-doped as sintering additives to inhibit decomposition of AlON during sintering for fast fabrication of highly transparent AlON ceramics. The phase transformation, microstructure evolution and densification process of the samples undoped and doped additive during heating were studied to investigate the densification mechanism. The results reveal that, compared to the samples undoped additive and single-doped with La2O3, the α-Al2O3 content of the samples co-doped with La2O3 and Y2O3 is significantly deduced at ≤1600 °C, which indicates that the decomposition of AlON is effectively inhibited by co-doping La2O3 and Y2O3. The reduction of α-Al2O3 along with the deceleration effect of La3+ on mass transfer, contributes to more small particles being conserved at high temperatures. Base on this, at later stage of sintering, benefiting from the enhanced mobility of grain boundary by Y3+, AlON ceramics with high relative density (99.79 %) and excellent transparency were obtained via pressureless sintering at 1880 °C for 2.5 h by co-doping 0.03 wt% La2O3 and 0.04 wt% Y2O3. The maximum transmittance of the fabricated AlON ceramics is up to 81.6 % at 3600 nm, and a transmittance of 76.0 % was measured at 400 nm. The ultra-low doping amount of La2O3 and Y2O3 and the high relative density should be the main reasons that lead to the outstanding transparency of the obtained AlON. Additionally, the fabricated AlON ceramics also exhibit a high Vickers hardness of 18.89 ± 0.18 GPa.

Direct cold sintering of translucent gamma-Al2O3 ceramics

Realizing Translucency in Aluminosilicate Glass at Ultralow Temperature Via Cold Sintering Process

Evolution from transparent SiO2 glass to ceramics enabled by cold sintering with a transient chemistry: H2SiO3

Thermal-assisted cold sintering study of Al2O3 ceramics: Enabled with a soluble γ-Al2O3 intermediate phase

A Fast Pressureless Sintering Method for Transparent AlON Ceramics by Using a Bimodal Particle Size Distribution Powder

Enhanced microwave dielectric properties of Al2O3 ceramics via a cold sintering assisted two-step sintering route

Hot-pressing of Translucent Y-α-SiAlON Ceramics Using Ultrafine Mixed Powders Prepared by Planetary Ball Mill

Two-step pressureless sintering of ultrafine powders for the preparation of high strength and transmittance AlON ceramics

Sintering Behavior, Microstructure and Mechanical Properties of Various Fluorine-Containing Y-SiAlON Glass-Ceramics

Fabrication of highly transparent AlON ceramics by inhibiting decomposition of AlON

Achieving fabrication of highly transparent Y 2 O 3 ceramics via air pre‐sintering by deionization treatment of suspension

Influence of Gd2O3 on the microstructure and properties of transparent MgAl2O4: Cr3+ ceramic

The hydrolysis process of γ-AlON powder and preparation of highly transparent ceramics with aqueous gel-casting

Novel transparent LiF ceramics enabled by cold sintering at 150 °C

Pressureless sintering of transparent AlON ceramic with assimilable γ‐Al 2 O 3 as sintering promoting additives

Transparent AlON ceramics by nitriding combustion synthesis precursors and pressureless sintering method

Fast pressureless sintering of highly transparent AlON ceramics by reducing Y enrichment with nano-sized granular Y 2 O 3 as additive

Water-Assisted Cold Sintering of Alumina Ceramics in SPS Conditions

Preparation of non-stoichiometric Gd2+xZr2O7+3x/2 transparent ceramics by vacuum sintering

Enhancing fluorescence properties in transparent glass ceramics via optimized Gd2O3/Ga2O3 ratios and crystallization conditions

Improved densification in cold sintering of gadolinia‐doped ceria with reactive sintering aids