Abstract:The aqueous zinc-ion batteries (ZIBs) have been considered as a promising energy storage device. However, the ion transfer at the Zn metal anode–electrolyte interface is limited by the sluggish kinetics resulting in high interface resistance. Herein, mesoporous TiO2 (m-TiO2) is coated on the Zn foil (Zn-TiO2) driving the ion's faster transfer to reduce interface resistance (70.1 Ω vs 799.3 Ω of bare Zn). The lower interface resistance is ascribed to shortening the ion transfer path provided by the mesoporous structure and the smaller Zn2+ absorption energy barrier of the surface of the Zn-TiO2 anode as well as the unobstructed ion transfer path at the crystal planes (100) of TiO2, which have been supported by the density functional theory (DFT) calculation and experiments. Therefore, the Zn-TiO2 anodes in the symmetrical cells display a low voltage hysteresis (36.5 mV) and long-term cycling stability (500 h at 4.4 mA cm–2). Especially, the Zn-TiO2/MnO2 full cells show superior cycling performance with a high capacity of 269.8 mAh g–1 after 50 cycles at 0.2 A g–1 and 210.9 mAh g–1 after 1000 cycles at 0.5 A g–1. The analysis of ion-transfer kinetics at the interface provides deep enlightenment and reference for the study of the metal anodes.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c18433?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c18433</a>.The SEM image of the Zn-20TiO2 surface; cross-section SEM images and galvanostatic cycling curves; galvanostatic cycling performance of symmetric cells; partial enlarged galvanostatic cycling curves of symmetrical cells; the SEM images and surface pictures; nucleation overpotential; the contact angle; calculation models of Zn absorbed on the surfaces; the XPS spectrum; the XRD results; the TEM results; nitrogen adsorption/desorption isotherms; the XRD patterns of MnO2; the discharge/charge curves; the long cycling performance at 1 A g–1; the SEM image of TiO2 after cycling; the TEM image of m-TiO2 after cycling; the cycling performance using a 2 M ZnSO4 electrolyte; the images of the separator; the linear relationships between Zre and ω–0.5; GITT and diffusion coefficient curves of full cells; cyclic voltammetry curves; SEM images of the electrode after cycling; comparison of cycling performance in the symmetrical cell; and comparison of charge transfer impedance in the symmetrical cell (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c18433/suppl_file/am0c18433_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

A New TiO2‐Based Cathode Material with Interface‐Dominated Storage Mechanism for Aqueous Zinc‐Ion Batteries

Lattice Expanded Titania As an Excellent Anode for an Aqueous Zinc-Ion Battery Enabled by a Highly Reversible H+-Promoted Zn2+ Intercalation

A high capacity TeO2 cathode for aqueous zinc-ion batteries

Titanium hexacyanoferrate/carbon nanotube composites as the cathode material for aqueous sodium/zinc ion batteries

Desolvation Effect Triggered by TiS2‐TiO2 Heterostructure for Ultrahigh‐Rate Aqueous Zinc‐Ion Batteries

Ultrathin surface coating of conductive and zincophilic titanium oxynitride enables stable zinc anodes for aqueous zinc-ion batteries

Layered TiS2 As a Promising Host Material for Aqueous Rechargeable Zn Ion Battery

Boosting Zn2+ Intercalation in High-Performance Aqueous Zinc-Ion Batteries with Coupling-Induced Biphase Interface

MXene‐Stabilized VS2 Nanostructures for High‐Performance Aqueous Zinc Ion Storage

Driving the Interfacial Ion-Transfer Kinetics by Mesoporous TiO 2 Spheres for High-Performance Aqueous Zn-Ion Batteries

Synergistic H + /Zn 2+ co-insertion mechanism in vanadium trioxide composited on carbon nanotubes cathode for aqueous zinc ion batteries

Structural engineering of cathodes for improved Zn-ion batteries

Electrochemical Performance of Ti<sub>3</sub>C<sub>2</sub>T<i><sub>x</sub></i>/MnO<sub>2</sub> Cathode in Aqueous Zinc Ion Batteries

Tannic acid assisted metal–chelate interphase toward highly stable Zn metal anodes in rechargeable aqueous zinc-ion batteries

A new In Situ Oxidized 2D Layered MnBi2Te4 Cathode for High-Performance Aqueous Zinc-Ion Battery.

Anion and Cation Co-Modified Vanadium Oxide for Cathode Material of Aqueous Zinc-Ion Battery

A quinoxalinophenazinedione covalent triazine framework for boosted high-performance aqueous zinc-ion batteries

Heterogeneous interface-boosted zinc storage of H2V3O8 nanowire/Ti3C2Tx MXene composite toward high-rate and long cycle lifespan aqueous zinc-ion batteries

High-surface-area titanium nitride nanosheets as zinc anode coating for dendrite-free rechargeable aqueous batteries

A π-conjugated organic compound with multiple active sites as a cathode material for high-rate aqueous zinc-ion batteries

Rationally designed hierarchical three-dimensional amorphous V2O5@Ti3C2Tx microsphere for high performance aqueous zinc-ion batteries