Abstract:The aqueous zinc-ion batteries (ZIBs) have been considered as a promising energy storage device. However, the ion transfer at the Zn metal anode–electrolyte interface is limited by the sluggish kinetics resulting in high interface resistance. Herein, mesoporous TiO2 (m-TiO2) is coated on the Zn foil (Zn-TiO2) driving the ion's faster transfer to reduce interface resistance (70.1 Ω vs 799.3 Ω of bare Zn). The lower interface resistance is ascribed to shortening the ion transfer path provided by the mesoporous structure and the smaller Zn2+ absorption energy barrier of the surface of the Zn-TiO2 anode as well as the unobstructed ion transfer path at the crystal planes (100) of TiO2, which have been supported by the density functional theory (DFT) calculation and experiments. Therefore, the Zn-TiO2 anodes in the symmetrical cells display a low voltage hysteresis (36.5 mV) and long-term cycling stability (500 h at 4.4 mA cm–2). Especially, the Zn-TiO2/MnO2 full cells show superior cycling performance with a high capacity of 269.8 mAh g–1 after 50 cycles at 0.2 A g–1 and 210.9 mAh g–1 after 1000 cycles at 0.5 A g–1. The analysis of ion-transfer kinetics at the interface provides deep enlightenment and reference for the study of the metal anodes.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c18433?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c18433</a>.The SEM image of the Zn-20TiO2 surface; cross-section SEM images and galvanostatic cycling curves; galvanostatic cycling performance of symmetric cells; partial enlarged galvanostatic cycling curves of symmetrical cells; the SEM images and surface pictures; nucleation overpotential; the contact angle; calculation models of Zn absorbed on the surfaces; the XPS spectrum; the XRD results; the TEM results; nitrogen adsorption/desorption isotherms; the XRD patterns of MnO2; the discharge/charge curves; the long cycling performance at 1 A g–1; the SEM image of TiO2 after cycling; the TEM image of m-TiO2 after cycling; the cycling performance using a 2 M ZnSO4 electrolyte; the images of the separator; the linear relationships between Zre and ω–0.5; GITT and diffusion coefficient curves of full cells; cyclic voltammetry curves; SEM images of the electrode after cycling; comparison of cycling performance in the symmetrical cell; and comparison of charge transfer impedance in the symmetrical cell (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c18433/suppl_file/am0c18433_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Desolvation Effect Triggered by TiS2‐TiO2 Heterostructure for Ultrahigh‐Rate Aqueous Zinc‐Ion Batteries

Lattice Expanded Titania As an Excellent Anode for an Aqueous Zinc-Ion Battery Enabled by a Highly Reversible H+-Promoted Zn2+ Intercalation

Helmholtz Plane Reconfiguration Enables Robust Zinc Metal Anode in Aqueous Zinc‐Ion Batteries

A New TiO2‐Based Cathode Material with Interface‐Dominated Storage Mechanism for Aqueous Zinc‐Ion Batteries

Driving the Interfacial Ion-Transfer Kinetics by Mesoporous TiO 2 Spheres for High-Performance Aqueous Zn-Ion Batteries

Boosting Zn2+ Intercalation in High-Performance Aqueous Zinc-Ion Batteries with Coupling-Induced Biphase Interface

Layered TiS2 As a Promising Host Material for Aqueous Rechargeable Zn Ion Battery

In situ constructing amorphous V2O5@Ti3C2Tx heterostructure for high-performance aqueous zinc-ion batteries

Enhanced Zn2+ transfer dynamics via a 3D bird nest-like VO2/MXene heterojunction for ultrahigh-rate aqueous zinc-ion batteries

Mitigating the dissolution of V2O5 in aqueous ZnSO4 electrolyte through Ti-doping for zinc storage

Regulating desolvation and homogenized ion flux towards highly reversible dendrite-free zinc anode

A novel TiSe2 (de)intercalation type anode for aqueous zinc-based energy storage

Polymer Chain‐Guided Ion Transport in Aqueous Electrolytes of Zn‐Ion Batteries

Facile Zn2+ Desolvation Enabled by Local Coordination Engineering for Long‐Cycling Aqueous Zinc‐Ion Batteries

Ultrastable and ultrafast 3D charge–discharge network of robust chemically coupled 1 T-MoS2/Ti3C2 MXene heterostructure for aqueous Zn-ion batteries

In‐situ Ultrafast Construction of Zinc Tungstate Interface Layer for Highly Reversible Zinc Anodes

Weak Solvation Effect Induced Optimal Interfacial Chemistry Enables Highly Durable Zn Anodes for Aqueous Zn-Ion Batteries.

An aqueous electrolyte densified by perovskite SrTiO 3 enabling high-voltage zinc-ion batteries

Hydrated Metal Vanadate Heterostructures as Cathode Materials for Stable Aqueous Zinc-Ion Batteries

Ultra‐Stable Aqueous Zinc Anodes: Enabling High‐Performance Zinc‐Ion Batteries via a ZnSiF6‐Derived Protective Interphase

Polyoxotungstate Featuring Zinc‐Ion‐Triggered Structural Transformation as An Efficient Electrolyte Additive for Aqueous Zinc‐Ion Batteries