Abstract:INO-ICAL is a proposed underground particle physics experiment to study the neutrino oscillation parameters by detecting neutrinos produced in the atmospheric air showers. Iron CALorimeter (ICAL) is to have 151 layers of iron stacked vertically, with active detector elements in between the iron layers. The iron layers will be magnetized to enable the measurement of momentum and charge of the $\mu^-$ (or $\mu^+$) produced by $\nu_\mu$ (or $\bar{\nu}_\mu$) interactions. Resistive Plate Chambers (RPCs) have been chosen as the active detector elements due to their large area coverage, uncompromised sensitivity, consistent performance for decades, as well as cost effectiveness. The major factors that decide the physics potential of the ICAL experiment are efficiency, position resolution and time resolution of the large area RPCs. A prototype detector called miniICAL (with 11 iron layers) was commissioned to understand the engineering challenges in building the large scale magnet and its ancillary systems, and also to study the performance of the RPC detectors and readout electronics developed by the INO collaboration. As part of the performance study of the RPC detectors, an attempt is made to improve the position and time resolution of them. Even a small improvement in the position and time resolution will help to improve the measurements of momentum and directionality of the neutrinos in ICAL. The Time-over-Threshold (ToT) of the RPC pulses (signals) is recorded by the readout electronics. ToT is a measure of the pulse width and consequently the amplitude. This information is used to improve the time and position resolution of the RPCs and consequently INO physics potential.

Measurement of Characteristic Impedance of Silicon Fiber Sheet based readout strips panel for RPC detector in INO

Characterization of 3 mm Glass Electrodes and Development of RPC Detectors for $INO-ICAL$ Experiment

Development of Glass Resistive Plate Chambers for INO

Optimisation and Characterisation of Glass RPC for India-based Neutrino Observatory Detectors

Study of RPC bakelite electrodes and detector performance for INO-ICAL

Measurement of electrical properties of electrode materials for the bakelite Resistive Plate Chambers

Design Realization and Characterization of A Position Sensitive Detector for Fast Optical Measurement

Effect of variations in the gas mixture compositions on the timing and charge of glass RPC

Effect of glass thickness variations on the performance of RPC detectors

Performance study of a bakelite RPC prototype built by new technique of linseed oil coating

Development of linseed oil-free bakelite resistive plate chambers

Characterization and Comparison of Glass Electrodes

Performances of silicone coated high resistive bakelite RPC

Improving Time and Position Resolution of RPC detectors using Time Over Threshold Information

Design and Analysis of Ingaas Pin Photodetectors Integrated on Silicon-On-Insulator Racetrack Resonators

Characterization of Silicon-Photomultipliers for a Cosmic Muon Veto detector

Design Method of Multi-Sine Signal for Broadband Impedance Measurement Considering Frequency Coupling Characteristic

Leak Test of Resistive Plate Chamber Gap by Monitoring Absolute Pressure

Characterizing Novel Indium Phosphide Pad Detectors with Focused X-ray Beams and Laboratory Tests

A Novel Readout Scheme for Muon Tomography Application in Material Identification

A new technique of linseed oil coating in bakelite RPC and the first test results