Abstract:Thin film silicon solar cells are believed to be promising candidates for continuing cost reduction in photovoltaic panels because silicon usage could be greatly reduced. Since silicon is an indirect bandgap semiconductor, its absorption coefficient is low for photons in the wavelength ranges between 600nm and 1100nm. For high efficiency thin film modules, effective light trapping is essential. Traditional schemes such as textured transparent conductive oxide (TCO) and metal reflector have several disadvantages such as enhanced surface recombination, parasitic losses at the TCO/metal interface, and the lack of ability to control and optimize the textured surface. We have previously proposed to employ a light trapping structure, which combines a self-assembled submicron grating and a distributed Bragg reflector (DBR) on the backside of thin film silicon solar cells. The DBR works as a one-dimensional photonic crystal to obtain almost 100% reflectivity. The grating scatters the incident light into oblique angles to significantly enhance the optical path length. Numerical calculations predict that by optimizing the feature sizes of the grating and DBR, up to 31% relative efficiency increase can be obtained, compared to the bare thin film Si. By using self-assembly, the organized grating structure can be formed spontaneously at a much lower cost. Current-voltage relations and quantum efficiency measurements were taken to verify the performance of our designed back structure. In the wavelength range of 600-900nm, photon absorption is greatly enhanced. As a result, more than 20% relative efficiency enhancement is achieved for 1.5um thin film silicon cells. These numerical and experimental results show that a light trapping design can be low-cost and increase efficiencies for high performance thin film Si solar cells.

Theoretical analysis of performance improvement of thin film solar cells with two-dimensional photonic crystals and distributed Bragg reflector textured structures

Photonic Crystal Structures for Light Trapping in Thin-Film Si Solar Cells: Modeling, Process and Optimizations

Improving thin-film crystalline silicon solar cell efficiencies with photonic crystals

Efficient Light Trapping Structure in Thin Film Silicon Solar Cells

Integrated Photonic Structures For Light Trapping In Thin-Film Si Solar Cells

Thin-film silicon solar cells: photonic design, process and fundamentals

Enhancement of light trapping for ultrathin crystalline silicon solar cells

Thin Film Silicon Solar Cell Design Based On Photonic Crystal And Diffractive Grating Structures

Effects of One-Dimensional Photonic Crystal on Thin Film Silicon Solar Cells

Numerical investigation of tandem photonic crystal filters for thermophotovoltaic applications

Enhanced Efficiency in Thin Film Solar Cells: Optimized Design With Front Nanotextured and Rear Nanowire-Based Light Trapping Structure

Effects of frequency upconversion layer and two-dimensional arrays of inverted nanocone hole on the performance of ultrathin crystalline silicon solar cells

High-efficiency photonic crystal solar cell architecture

Advanced Light-Trapping Effect of Thin-Film Solar Cell with Dual Photonic Crystals

Progress in thin-film silicon solar cells based on photonic-crystal structures

Photonic crystal and Ti nanoparticles enhanced high-absorption GaAs thin-film solar cell

Design And Analysis Of 2d Photonic Crystals For Nano-Structured Solar Cells

Optimized photonic crystal structure for DSSC

Perovskite/c-Si tandem solar cell with inverted nanopyramids: realizing high efficiency by controllable light trapping

An optical study on the enhanced light trapping performance of the perovskite solar cell using nanocone structure

Multilayers strategy with a mixed CdTe/ZnTe absorber layer for optical trapping and efficiency improvement in CdTe-based solar – SCAPS modelling