Abstract:In permafrost regions, rock engineering projects inevitably suffer from the effects of freeze-thaw (F-T) cycles under complex geographical and climatic conditions. Under F-T cycles, the damage and deterioration of macro- and microdefects, such as joints and cracks, in the rock will reduce the structural stability of the rock and even lead to frost damage in rock engineering. In this study, through indoor F-T cycle tests, uniaxial/triaxial compression tests, acoustic emission monitoring, and discrete element method (PFC 3D) modeling, the macro/microscopic mechanical characteristics and crack propagation behavior of sandstone-like samples with single cracks under F-T cycles were investigated. The results show that the compressive strength of sandstone-like samples with single cracks tends to decrease and then increase with an increasing crack angle and exhibits a stable decreasing trend with increasing F-T cycles, indicating a significant crack angle effect and F-T deterioration effect. Additionally, the confining pressure has an inhibiting effect on the F-T deterioration of samples, and there is a mutual inhibition relationship between the F-T deterioration effect and the crack angle effect. The characteristics of the acoustic emission signals during the loading process of sandstone-like samples with single cracks show good consistency with the stress-strain curves. The analysis of fracture mechanisms based on rise time/amplitude (RA) and average frequency (AF) is consistent with the macroscopic failure modes observed in the experiments. Moreover, with an increase in the number of F-T cycles, the number of tension cracks in the sandstone-like samples with single cracks increases, while the number of shear cracks decreases. The crack propagation behavior of sandstone-like samples with single cracks obtained through discrete element simulations (PFC 3D) is mainly divided into four stages: Stage I - initial calm stage, Stage II - crack initiation stage, Stage III - crack propagation stage, and Stage IV - failure stage. The simulated mechanical properties and failure modes agree well with the experimental results, and five crack propagation modes of sandstone-like samples with single cracks under F-T cycles were proposed: direct tension (DT), relative tension (RT), shear-tension (ST), direct shear (DS) and relative shear (RS).

On the decay of fracture toughness of sandstone subjected to freeze–thaw cycles

Energy evolution and macro-micro failure mechanisms of frozen weakly cemented sandstone under uniaxial cyclic loading and unloading

Fracture behavior of yellow sandstone under freeze–thaw cycles with varied saturation states: An investigation of mode I fracture

Fracture mechanical properties of sandstone with pre-fabricated cracks under freeze–thaw cycles

Quantitative Study of the Failure Characteristics of Sandstone with Freeze–Thaw Damage: Insight into the Cracking Behavior

Surface crack evolution patterns in freeze-thaw damage of fissured rock bodies

Experimental Investigation on Fracture Behavior and Mechanical Properties of Red Sandstone Subjected to Freeze–Thaw Cycles

Study on the microscopic damage evolution and dynamic fracture properties of sandstone under freeze-thaw cycles

Macroscopic and microscopic mechanical characteristics and crack propagation behavior of sandstone-like samples with single cracks under freeze-thaw cycles: Experimental and numerical simulation

Deterioration mechanisms of tuff with surface fractures under freeze–thaw cycles

Experimental and DEM simulations of the mechanical properties of rock under freeze–thaw cycles

Decay function and damage strain model of fresh sandstone subjected to freeze–thaw cycles

Study on the mechanical properties of saturated red sandstone under freeze–thaw conditions

Experimental study on effect of freeze-thaw cycles on dynamic mode-Ι fracture properties and microscopic damage evolution of sandstone

Tensile mechanical behavior and fracture characteristics of sandstone exposed to freeze-thaw treatment and dynamic loading

Effect of freeze–thaw cycle on physical and mechanical properties and damage characteristics of sandstone

Analysis of fracture toughness deterioration and instability model of dangerous rock masses under freeze–thaw cycles

Strength degradation characteristics and damage constitutive model of sandstone under freeze–thaw cycles

Research on triaxial compressive mechanical properties and damage constructive model of post-thawing double-fractured quasi-sandstones with different angles

Effect of freezing temperature and number of freeze–thaw cycles on mode I and mode II fracture toughness of sandstone

Deterioration of dynamic fracture characteristics, tensile strength and elastic modulus of tight sandstone under dry-wet cycles