Analysis of the dust–methane two-phase coupling blowdown effect at different air duct positions in an excavation anchor synchronous tunnel

Wen Nie,Qianqian Xue,Lidian Guo,Faxin Li,Yun Hua,Qiang Liu,Ning Sun,Chenwang Jiang,Fengning Yu
DOI: https://doi.org/10.1007/s11356-023-27951-w
IF: 5.8
2023-06-27
Environmental Science and Pollution Research
Abstract:Bolter miners are being increasingly used. Unfortunately, this mining technology causes a considerable amount of air pollution (especially by methane and dust) during excavation. In this study, the multiphase coupling field of airflow–dust–methane for different distances between the pressure air outlet and the working face (Lp) was simulated by using the FLUENT software. The migration law of pollutants in the multiphase coupling field was analyzed, and the distance parameters between the pressure air outlet and the working face were optimized. Finally, the simulation results were verified based on the field measurement results. We found that the blowdown effect was more obvious when 14 m ≤ Lp < 16 m compared with other conditions. The peak value of dust concentration within this distance range was the smallest (44.4% lower than the highest peak value, which was verified when Lp = 18 m), while the methane concentration was < 0.6%. A high-concentration area (where methane concentration > 0.75%), identified near the walking part of the bolter miner, was 13 m shorter than the largest (when Lp = 18 m). Therefore, we determined that the optimal blowdown distance would be 14 m ≤ Lp < 16 m. Within this range, the dust removal and methane dilution effects are optimal, effectively improving the tunnel air quality and providing a safe and clean environment for mine workers.
environmental sciences
What problem does this paper attempt to address?