Abstract:Accurate measurement of CO2 generated from different emission sources is the basis for controlling CO2 emissions and mitigating global warming. With advantages of high accuracy and rapid response, isotope analyzers using spectroscopic techniques, particularly those using cavity ring-down spectroscopy, have been widely used for CO2 emissions monitoring. However, these analyzers often face challenges such as spectral interference from impurity gases and unstable temperature control within the optical cavity in isotope analyzers. To address these challenges, this paper proposes a low-temperature optical cavity scheme utilizing a split Stirling-type pulse tube cryocooler. Combining thermal boundary conditions with particle swarm optimization, a dynamic cooling and temperature control model of the optical cavity was established in MATLAB. The model subsequently analyzed the cooling process, temperature control, and stability of the optical cavity. After 120 h, the simulations showed that the central part of the optical cavity had cooled to 126.4 K with a heat leakage of 8.90 W, in agreement with the experimental results that stabilized at 126.8 K. The temperature fluctuations remained within 0.1 K/h while controlling an overall temperature of 170 K with a temperature difference of +/- 5 K. Changes in the electrical input power of cryocooler had no influence on the temperature distribution. This advancement not only lowers the operating temperature of the optical cavity to minimize spectral interference but also enhances the precision and efficiency of temperature control.

Design and realization of a 3-K cryostat for a 10-cm ultrastable silicon cavity

An Ultrastable 1397-Nm Laser Stabilized by a Crystalline-Coated Room-Temperature Cavity.

An ultra-stable cryogenic sapphire cavity laser with an instability of $1.9\times10^{-16}$ based on a low vibration level cryostat

Ultra-stable Cryogenic Sapphire Cavity Laser with an Instability Reaching 2 × 10−16 Based on a Low Vibration Level Cryostat

Fabrication of Optical Cavities with Femtosecond Laser Pulses

Towards a sub-kelvin cryogenic Fabry-Perot silicon cavity

An Ultra-Stable Laser Based on a Room-Temperature Optical Cavity with Crystalline Coatings

Cryogenic sapphire optical reference cavity with crystalline coatings at $\mathrm{ 1 \times 10^{-16}}$ fractional instability

Cryogenic sapphire optical reference cavity with crystalline coatings at 1 × 10-16 fractional frequency instability

Cryogenic photonic resonator with $10^{-17}$/s drift

Ultra-stable laser with average fractional frequency drift rate below $5\times10^{-19}/\mathrm{s}$

Vibration Property of a Cryogenic Optical Resonator within a Pulse-Tube Cryostat

Numerical Simulation and Experimental Verification of Dynamic Cooling and Temperature Control of the Optical Cavity in a Co2 Isotope Analyzer

Closed-cycle, low-vibration 4 K cryostat for ion traps and other applications

A mechanically stable and tunable cryogenic Fabry-Perot microcavity

Investigation on the thermal property of a hydroxide catalysis bonded cryogenic cavity

Ultrastable lasers: investigations of crystalline mirrors and closed cycle cooling at 124 K

A highly stable and fully tunable open microcavity platform at cryogenic temperatures

Frequency stability of cryogenic silicon cavities with semiconductor crystalline coatings

Compact Frequency-Stabilization Scheme for Laser Cooling of Polar Molecules

Low-vibration cryogenic test facility for next generation of ground-based gravitational-wave observatories