Abstract:Summary form only given. Recently, the state-of-the-art of lithium-niobate-on-insulator (LNOI) has been reviewed [1]. In analogy to silicon-on-insulator (SOI), the new material platform for integrated optics with wafers of up to 3” diameter enables the fabrication of optical waveguides with small cross-sections and small bending radii due to the high refractive index contrast. As a consequence, ultra-compact photonic integrated devices such as ring resonators and photonic crystal structures have been developed.Here we demonstrate also Er-doped LNOI, which might become an ideal material for nano-optical amplifiers and lasers. Doping is achieved by pre-diffusion of Er into the upper LN wafer before bonding [2], and the resulting Er concentration is about 1020 cm-3. Ridges of different width w = (2.5 - 10) μm were fabricated on these LNOI substrates (LN thickness of 960 nm) using precision diamond-blade dicing which results in smooth side walls of the fabricated waveguides. We present results of a first investigation of the erbium centers using Raman and fluorescence spectroscopy of planar and ridge waveguides in Er:LNOI.Characterization of the waveguides was performed using Raman and fluorescence spectroscopy. Spectral scans were obtained using a scanning confocal microscope and a 488 nm laser. Besides line broadening that may be attributed to internal strain in the bonded layer, analysis of the Raman spectrum shows no significant difference between the waveguide and the bulk material. However, the erbium emission of the 4H15/2 and 4S3/2 to the 4I15/2 contains several differences in the intensity ratios indicating that the relative transition probabilities are different for the smart cut waveguide. While Raman intensity has a linear relationship with pump power, the intensity of the Er emission starts saturating at pump levels of only a few mW. To investigate fluorescence of the 4I13/2 - 4I15/2 transition inside the formed ridges, a fiber coupled lase- with a wavelength of 980 nm is used for pumping. The rhs of the figure above shows a diced ridge and the green fluorescence that can be observed when the ridge is pumped at 980 nm. An example of the IR fluorescence is given on the right of the above figure using 40 mW of pump light, with the spectrum of an erbium doped fiber as a reference. The emission is broadened and maxima are shifted to longer wavelengths, which may be attributed to defects induced by implantation, re-absorption of fluorescence light, and contributions by amplified spontaneous emission due to the waveguiding effect.

Experimental evidence for preservation of electro-optic property in titanium-diffused lithium niobate waveguide

Fabrication of titanium in-diffusion waveguide in the PIN-PMN-PT single crystal

Wavelength dependence of electro-optic effect in tetragonal lead magnesium niobate lead titanate single crystals

Electro-Optic Effect Induced by Thermal Poling in Sio2 Ridge Waveguides

Relationship Between the Thermoelectric Properties and Infrared Emissivity of Nb-Doped TiO2

Optical Characterization and Stability Study of LiNbO3 Optical Waveguides Fabricated by Buffered Acid

Lithium–Niobate Channel Waveguide for the Realization of Long-Period Gratings

Enhancement of electro-optic properties in liquid crystal devices via titanium nanoparticle doping

TE/TM mode electro-optic conversion based on titanium diffusion lithium niobate waveguide with polarization-maintained fiber structure

Mg-Ion Indiffusion of Lithium-Niobate Single-Crystal Fiber

Low loss titanium dioxide strip loaded waveguide on thin-film lithium niobate at 1550nm

Improving Thermal Stability of LiNbO 3 Based Electro‐optical Electric Field Sensor by Depositing a TiO 2 Film

Cryogenic Electro-Optic Polarisation Conversion in Titanium in-diffused Lithium Niobate Waveguides

Effect of Li/Nb ratio on structure and photorefractive properties of Zn:Fe:LiNbO<sub>3</sub> crystals

Fluorescence in planar and ridge waveguides fabricated in Erbium-Doped lithium-niobate-on-insulator (Er:LNOI)

Cryogenic electro-optic modulation in titanium in-diffused lithium niobate waveguides

Pseudo-dielectric functions, band-to-band transitions, and dielectric-related factors in a single-crystal LiTi 2 O 4 thin film

Index contrast tunability of LiNbO$_3$ waveguides obtained by thermal treatment

Integrated transition edge sensors on titanium in-diffused lithium niobate waveguides

The Test and Analysis for Thermo-Optic Effect of Silicon Resin

Electrically Generated Optical Waveguide in a Lithium-Niobate Thin Film.