Abstract:The emission of volatile organic compounds (VOCs) significantly contributes to air pollution and poses a serious threat to human health. Benzene, one of the most toxic VOCs, is difficult for the human body to metabolize and is classified as a Group 1 carcinogen. The development of efficient adsorbents for removing trace amounts of benzene from ambient air is thus of great importance. In this work, we studied the benzene adsorption properties of four Zr-based metal-organic frameworks (Zr-MOFs) through static volumetric and dynamic breakthrough experiments. Two previously reported Zr-MOFs, BUT-12 and STA-26, were prepared with a tritopic carboxylic acid ligand (H3L1) functionalized with three methyl groups, and STA-26 is a 2-fold interpenetrated network of BUT-12. Two new isoreticular Zr-MOFs, BUT-12-Et and STA-26-Et, were synthesized using a similar ligand, H3L2, where the methyl groups are replaced with ethyl groups. There are mesopores in BUT-12 and BUT-12-Et and micropores in STA-26 and STA-26-Et. The four Zr-MOFs all showed high stability in liquid water and acidic aqueous solutions. The microporous STA-26 and STA-26-Et showed much higher benzene uptakes than mesoporous BUT-12 and BUT-12-Et at room temperature under low pressures. Particularly, the benzene adsorption capacity of STA-26-Et was high up to 2.21 mmol/g at P/P0 = 0.001 (P0 = 12.78 kPa), higher than those of the other three Zr-MOFs and most reported solid adsorbents. Breakthrough experiments confirmed that STA-26-Et could effectively capture trace benzene (10 ppm) from dry air; however, its benzene capture capacity was reduced by 90% under humid conditions (RH = 50%). Coating of the crystals of STA-26-Et with polydimethylsiloxane (PDMS) increased the hydrophobicity of the exterior MOF surfaces, leading to a more than 2-fold improvement in its benzene capture capacity in the breakthrough experiment under humid condition. PDMS coating of STA-26-Et likely slowed down the water adsorption process, and thus, the adsorbent afforded more efficient capture of benzene. This work demonstrates that modifying both the interior and exterior surfaces of MOFs can effectively enhance their performance in capturing trace benzene from ambient air, even under humid conditions. This finding is meaningful for the development of new adsorbents for effective air purification applications.

On the capture of ultralow-level benzene in indoor environments: Experiments, modeling and molecular simulation

Research on Nonsteady-State Adsorption and Regulation Towards Stabler Adsorption for Benzene over Single-Wall Carbon Materials.

Adsorption equilibrium of activated carbon amid fluctuating benzene concentration in indoor environments

Interior and Exterior Surface Modification of Zr-Based Metal-Organic Frameworks for Trace Benzene Removal

Influence of pore volume and surface area on benzene adsorption capacity of activated carbons in indoor environments

Targeted improvement of narrow micropores in porous carbon for enhancing trace benzene vapor removal: Revealing the adsorption mechanism via experimental and molecular simulation

Adsorption Behavior of Benzene on Clay Mineral Surfaces at Different Temperatures and Air Humidity Based on Molecular Simulation

Control of the Pore Chemistry in Metal-Organic Frameworks for Efficient Adsorption of Benzene and Separation of Benzene/cyclohexane

Improving the adsorption performance of non-polar benzene vapor by using lignin-based activated carbon

A Concise Review on Porous Adsorbents for Benzene and Other Volatile Organic Compounds

Thermodynamically and Kinetically Enhanced Benzene Vapor Sensor Based on the Cu-TCPP-Cu MOF with Extremely Low Limit of Detection

Study on the adsorption behavior of benzene mixture in water on different materials by headspace gas chromatography

Carbon Functionalized Mesoporous Silica-Based Gas Sensors for Indoor Volatile Organic Compounds

Trace benzene capture by decoration of structural defects in metal–organic framework materials

Simplified methods for characterizing dynamic sorption of SVOCs on viscous particles

Experimental validation of adsorption filter model under dynamic VOC concentrations: Prediction of long-term efficiency

Industrial-Scale Benzene Adsorption: Assessment of a Baseline One-Dimensional Temperature Swing Model against Online Industrial Data

Experimental evaluation of benzene adsorption in the gas phase using activated carbon from waste biomass

Metal‐Organic Framework Based Sensors for Benzene Vapor

The potential utility of HKUST-1 for adsorptive removal of benzene vapor from gaseous streams using a denuder versus a packed-bed adsorption system

A new method to evaluate the performance of adsorbents for indoor VOCs purification