Abstract:Photovoltaic (PV) modules are recently employed in photovoltaic visible light communication (PVLC) for simultaneous energy harvesting and visible light communication. A PV-based receiver features large signal output, easy optical alignment, and self-powered operation. However, PV modules usually have a severe bandwidth limitation when used as passive photodetectors. In this paper, we systematically investigate the internal impedance dynamic of PV modules and how that affects their frequency response characteristics under different illuminances. We propose a simplified yet accurate dynamic PV mode AC detection model to capture the frequency response characteristics of a PVLC receiver. The model is validated with the impedance spectroscopy characterization methodologies. Experimental results show that a PV module's internal resistance and capacitance depend on incident illuminance, affecting PV's frequency response. The bandwidth is exacerbated under indoor environments with low illuminance levels due to the increment of internal resistance for PV modules. The RC constant can be reduced for PVLC receivers working near open-circuit voltage conditions by adding a moderate local light to decrease the internal resistance value. For practical implementation, PVLC receivers will employ a load for data recovery. We show that adjusting the forward bias conditions can simultaneously reduce the resistance and capacitance values. With the optimization of equivalent trans-impedance, the data rate of a Cadmium telluride (CdTe) PV module achieves a 3.8 times enhancement under 200 lux. We also demonstrate that the BER of a 5-Mbit/s eight-level pulse amplitude modulation (PAM8) signal can be reduced from 9.8*10-2 to 1.4*10-3 by maximizing the transimpedance gain-bandwidth product.

LED Receiver Impedance and Its Effects on LED-LED Visible Light Communications

Challenges and Prospects of Indoor Visible Light Communication by High Power White LED

Impact of LED Transmitters’ Radiation Pattern on Received Power Distribution in a Generalized Indoor VLC System

LED Based High-Speed Visible Light Communications

LED Communication – Devices, Circuits, and Optical Modulation Technology

Self-powered Weak Light LED-LED Communications

Joint LED dimming and high capacity visible light communication by overlapping PPM

Study On The Influence Of Led Pn Junction Area On Modulation Bandwidth In Visible Light Communication

Effects of LED Lighting Degradation and Junction Temperature Variation on the Performance of Visible Light Communication

Uniformity of reshaped beam by diffractive optical elements with light-emitted diode illumination

Visible Light Communication Optimization under Lighting Constraints

Experimental Demonstration of LED Based Underwater Wireless Optical Communication

Research of Key Enabling Technologies for High-Speed Visible-Light Communication

Performance of Short-Range Non-Line-of-sight LED-based Ultraviolet Communication Receivers

A Dynamic Model for Frequency Response Optimization in Photovoltaic Visible Light Communication

Accuracy of the Point-Source Model of a Multi-LED Array in High-Speed Visible Light Communication Channel Characterization

Key Technologies of Visible Light Communications with Multiple LEDs

Experimental demonstration of a RGB-LED based visible light communication system employing Carrierless Amplitude and Phase modulation

Research and Design of LED Light Suppression Flicker Technology in Visible Light Communication Technology

Effect of white LED DC-bias on modulation speed for visible light communications

Line-of-sight visible light communication system design and demonstration