Abstract:A high-power light-emitting diode (LED) panel-lamp connected in series with a low-complexity modulation circuit using metal–oxide–semiconductor field-effect transistor (MOSFET) is proposed for an indoor visible-light communication system. The MOSFET modulation circuit consists of a high-speed MOSFET and a shunt resistor, in which the MOSFET gives a variable load driven by the data bit stream and the shunt resistor can tune the modulation depth of the transmitter. In addition, only focusing optical lens is employed in the receiver but no collimation optical lens is adopted in the transmitter to increase the working area. Although the largest data rate is limited to 2 Mbps, the longitudinal communication distances is as long as 6 m; moreover, the maximum horizontal distance is up to 5 m (~ 78.5 m<sup>2</sup> in area) along with 3 m in longitudinal distance at the data rates of 1 Mbps. Compared with the traditional Bias-Tee configuration, the proposed MOSFET configuration leads to a lower data rate but a higher modulation depth as well as much larger working area. To the best of our knowledge, this is the largest working area at such a high data rate with on–off-keying using a single LED luminary without collimation optical lens. The system has the inherent ability to realize pulse amplitude modulation (PAM). The 4-PAM is demonstrated to double the data rates.

Self-powered Weak Light LED-LED Communications

Experimental Demonstration of LED Based Underwater Wireless Optical Communication

Challenges and Prospects of Indoor Visible Light Communication by High Power White LED

Long-Distance Visible Light Communication Based on Light Emitting Diode Source

Single LED-based 46-m underwater wireless optical communication enabled by a multi-pixel photon counter with digital output

Visible-light communication using high-power LED panel-lamp and low-complexity MOSFET circuit

2.0-Gb/s Visible Light Link Based on Adaptive Bit Allocation OFDM of a Single Phosphorescent White LED

2.32 Gbit/S Phosphorescent White Led Visible Light Communication Aided by Two-Staged Linear Software Equalizer

LED Based High-Speed Visible Light Communications

Optimized 481 Mb/s Visible Light Communication System Using Phosphorescent White LED

Real-time Bi-Directional Visible Light Communication System Utilizing a Phosphor-Based LED and RGB LED

Demonstration of 575-Mb/s Downlink and 225-Mb/s Uplink Bi-Directional SCM-WDM Visible Light Communication Using RGB LED and Phosphor-Based LED

Utilization of Optical OFDM Modulation on Blue LED VLC Datacom Without Equalization for 4 m Wireless Link

Beyond 25 Gbps Optical Wireless Communication Using Wavelength Division Multiplexed LEDs and Micro-Leds.

Visible Light Communication Performance in Weak Illumination Environment

Hidden Markov Model Based Signal Characterization for Weak Light Communication

A High-Speed Visible Light Communication System Using Pairs of Micro-Size LEDs

Full-duplex high-speed indoor optical wireless communication system based on a micro-LED and VCSEL array

Experimental Investigation of Underwater Weak Optical Communication Using a Photomultiplier Tube Receiver

Visible light communication based on wavelet packet division multiplexing

1.6 Gbit/s phosphorescent white LED based VLC transmission using a cascaded pre-equalization circuit and a differential outputs PIN receiver.