Abstract:Wireless electromagnetic sensing is a passive, non-destructive technique for measuring physical and chemical changes through permittivity or conductivity changes. However, the readout is limited by the sensitivity of the materials, often requiring complex sampling, particularly in the GHz range. We report capacitive dielectric temperature sensors based on polydimethylsiloxne (PDMS) loaded with 10 vol% of inexpensive, commercially available conductive fillers including copper powder (Cu), graphite powder (GP) and milled carbon fibre powder (CF). The sensors are tested in the range of 20°C to 110°C, with enhanced sensitivity from 20 to 60°C, and relative response of up to 85.5% at 200 MHz for CF loaded capacitors. Additionally, we demonstrate that operating frequency influences the relative sensing response by as much as 15.0% in loaded composite capacitors. Finally, we demonstrate the suitability of PDMS-CF capacitors as a sensing element in wirelessly coupled chipless resonant coils tuned to 6.78 MHz with a readout response, in the resonant frequency of the sensor. The wireless readout of the PDMS-CF chipless system exhibited an average sensitivity of 0.38 %°C-1 which is a 40x improvement over a pristine PDMS-based capacitive sensor and outperforms state of the art frequency-domain radio frequency (RF) temperature sensors including carbon-based composites at higher loadings. Exploiting the high sensitivity, we interrogate the sensor wirelessly using a low-cost and portable open-source NanoVNA demonstrating a relative response in the resonant frequency of the reader coil of 48.5%, with the response in good agreement with the instrumentation-grade vector network analyzers (VNAs), demonstrating that the sensors could be integrated into an inexpensive and portable measurement setup that does not rely on specialty equipment or highly trained operators.

Capacitive Sensing for Magnetic Nanoparticles in Molecular Communication

MagneComm: Magnetometer-based Near-Field Communication.

MagneComm+: Near-Field Electromagnetic Induction Communication with Magnetometer

Optical Micro/nanofibre Embedded Soft Film Enables Multifunctional Flow Sensing in Microfluidic Chips

Magnetic Nanoparticle Based Molecular Communication in Microfluidic Environments

Magnetic Steering of Superparamagnetic Nanoparticles in Duct Flow for Molecular Communication: A Feasibility Study

Large-Area Conductor-Loaded PDMS Dielectric Composites for High-Sensitivity Wireless and Chipless Electromagnetic Temperature Sensors

A Miniature Resonant Magnetic Field Probe Integrated with MLCC

Amplitude Modulation in a Molecular Communication Testbed with Superparamagnetic Iron Oxide Nanoparticles and a Micropump

Multiparametric Modulation of Magnetic Transduction for Biomolecular Sensing in Liquids

A Novel Dual Modality Sensor With Sensitivities to Permittivity, Conductivity, and Permeability

Detection of magnetic nanoparticles (MNPs) using spin current nano-oscillator (SCNO) biosensor: A frequency-based rapid, ultra-sensitive, magnetic bioassay

Capacitive detection of magnetostriction, dielectric constant, and magneto-caloric effects in pulsed magnetic fields

Chemical gas sensor based on a novel capacitive microwave flexible transducer and composite polymer carbon nanomaterials

Experimental System for Molecular Communication in Pipe Flow With Magnetic Nanoparticles

Development of a Microfluidic Chip System with Giant Magnetoresistance Sensor for High-Sensitivity Detection of Magnetic Nanoparticles in Biomedical Applications

Sensitive Magnetic Force Detection with a Carbon Nanotube Resonator

A capacitive-pulse model for nanoparticle sensing by single conical nanochannels

A Novel Biomimetic Magnetosensor Based on Magneto-Optically Involved Conformational Variation of MagR/Cry4 Complex

Resonance-based Detection of Magnetic Nanoparticles and Microbeads Using Nanopatterned Ferromagnets

An alternative capacitive transducer design for sensitivity enhancement in MEMS Lorentz force magnetometers