Sensitive Magnetic Force Detection with a Carbon Nanotube Resonator

Kyle Willick,Chris Haapamaki,Jonathan Baugh

DOI: https://doi.org/10.1063/1.4868686

2014-02-27

Abstract:We propose a technique for sensitive magnetic point force detection using a suspended carbon nanotube (CNT) mechanical resonator combined with a magnetic field gradient generated by a ferromagnetic gate electrode. Numerical calculations of the mechanical resonance frequency show that single Bohr magneton changes in the magnetic state of an individual magnetic molecule grafted to the CNT can translate to detectable frequency shifts, on the order of a few kHz. The dependences of the resonator response to device parameters such as length, tension, CNT diameter, and gate voltage are explored and optimal operating conditions are identified. A signal-to-noise analysis shows that in principle, magnetic switching at the level of a single Bohr magneton can be read out in a single shot on timescales as short as 10 microseconds. This force sensor should enable new studies of spin dynamics in isolated single molecule magnets, free from the crystalline or ensemble settings typically studied.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The key problem that this paper attempts to solve is to develop a technology capable of achieving high - sensitivity and rapid read - out of single - molecule magnetic moments (at the Bohr magneton level). Specifically, the authors proposed a sensitive magnetic force detection technology based on suspended carbon nanotube (CNT) mechanical resonators, combined with the magnetic field gradient generated by ferromagnetic gate electrodes, to achieve this goal.

### Main Problems and Solutions

1. **High - sensitivity magnetic moment detection**:
- **Existing challenges**: Currently, although some experiments have approached the sensitivity at the Bohr magneton level, the bandwidth is low and high - fidelity, high - speed read - out cannot be achieved.
- **Solution**: By using suspended carbon nanotube (CNT) mechanical resonators and combining with the strong magnetic field gradient generated by ferromagnetic gate electrodes, the frequency shift caused by a single Bohr magneton change can be detected.

2. **Fast response**:
- **Existing challenges**: It is required to achieve fast, single - shot magnetic state read - out in an external magnetic field of any strength.
- **Solution**: Optimize the design parameters of the sensor (such as length, tension, CNT diameter, and gate voltage) to achieve the best sensitivity and response speed.

3. **New research area**:
- **Existing challenges**: Traditional magnetic research is usually limited to crystal or aggregate environments.
- **Solution**: This new detection technology will allow spin dynamics research on isolated single - molecule magnets, not limited by crystal or aggregate environments.

### Technical Principles

- **Magnetic force action mechanism**:
The magnetic field gradient generates a point force on the CNT, and the formula is:
\[
\vec{F}_{\text{mag}}=\nabla(\vec{m}\cdot\vec{B})
\]
where \(\vec{m}\) is the magnetic moment vector of the nanomagnet, and \(\vec{B}\) is the magnetic field at the position of the nanomagnet.

- **Resonant frequency change**:
A single Bohr magneton change can lead to a significant shift in the resonant frequency, and the formula is:
\[
\Delta f_0\approx\frac{m_z}{r^3}\left(\frac{\partial B_z}{\partial x}\right)
\]

### Experimental Verification

- **Numerical calculation**:
Through numerical simulation, the authors showed the influence of different device parameters (such as length, diameter, gate voltage, etc.) on the resonant frequency and determined the optimal working conditions.

- **Noise analysis**:
The analysis shows that in principle, the magnetic state switching of a single Bohr magneton can be read out on a time scale as short as 10 microseconds.

### Application Prospects

This technology is expected to be used to study the spin dynamics of single - molecule magnets (SMMs), especially in high magnetic fields, which is crucial for a comprehensive understanding of spin physics. In addition, it can be combined with Ramsey interference fringe experiments to evaluate the spin decoherence and relaxation time scales of a single SMM.

In summary, this paper proposes an innovative magnetic force detection method, which solves the limitations of existing technologies in sensitivity and response speed, and opens up new avenues for the research of single - molecule magnets.