Abstract:A novel microfluidic picoliter-scale sample introduction approach was developed by combining the spontaneous injection approach with a capillary electrophoresis (CE) system based on a short capillary and slotted-vial array. A droplet splitting phenomenon at the capillary inlet end during the spontaneous sample introduction process was observed for the first time. On the basis of this phenomenon, a translational spontaneous injection approach was established to reduce sample injection volumes to the sub-100 pL range. A versatile high-speed capillary electrophoresis (HSCE) system was built on the basis of this sample injection approach with separation performance comparable to or even better than those reported in microfluidic chip-based CE systems. The HSCE system was composed of a short fused-silica capillary and an automated sample introduction system with slotted sample and buffer reservoirs and a computer-programmed translational stage. The translational spontaneous sample injection was performed by linearly moving the stage, allowing the capillary inlet first to enter the sample solution and then removing it. A droplet was left at the tip end and spontaneously drawn into the capillary by surface tension effect to achieve sample injection. The stage was continuously moved to allow the capillary inlet to be immersed into the buffer solution, and CE separation was performed by applying a high voltage between the buffer and waste reservoirs. With the use of the novel system, high-speed and efficient capillary zone electrophoresis (CZE) separation of a mixture of five fluorescein isothiocyanate (FITC) labeled amino acids was achieved within 5.4 s in a short capillary with a separation length of 15 mm, reaching separation efficiencies up to 0.40 microm plate height. Outstanding peak height precisions ranging from 1.2% to 3.7% RSD were achieved in 51 consecutive separations. By extension of the separation length to 50 mm, both high-speed and high-resolution CZE separation of eight FITC-labeled amino acids could be obtained in less than 21 s with theoretical plates ranging from 163,000 to 251,000 (corresponding to 0.31-0.20 microm plate heights). The present HSCE system also allowed fast chiral separations of FITC-labeled amino acids under micellar electrokinetic chromatography (MEKC) mode within 6.5 s.

High-Throughput Capillary Liquid Chromatography Using a Droplet Injection and Application to Reaction Screening

Capillary gas chromatographic injection system for large sample volumes

Portable Capillary Liquid Chromatography for Pharmaceutical and Illicit Drug Analysis

Online Monitoring of Small Volume Reactions Using Compact Liquid Chromatography Instrumentation

Microfluidic Sequential Injection Analysis in a Short Capillary

Compact Ultrahigh-Pressure Nanoflow Capillary Liquid Chromatograph.

Exploring a reversible adaptation of conventional HPLC for capillary-scale operation

A High-Throughput Continuous Sample Introduction Interface for Microfluidic Chip-Based Capillary Electrophoresis Systems.

Optimization Of The Interface For Coupling Capillary High Performance Liquid Chromatography With Capillary Electrophoresis In Comprehensive Two-Dimensional System

Valveless gated injection for microfluidic chip-based liquid chromatography system with polymer monolithic column.

Microfluidic Picoliter-Scale Translational Spontaneous Sample Introduction for High-Speed Capillary Electrophoresis

High-speed gradient parallel liquid chromatography/tandem mass spectrometry with fully automated sample preparation for bioanalysis: 30 seconds per sample from plasma

Small footprint liquid chromatography-mass spectrometry for pharmaceutical reaction monitoring and automated process analysis

Coupling Liquid Chromatography/Mass Spectrometry Detection with Microfluidic Droplet Array for Label-Free Enzyme Inhibition Assay

Storing liquid chromatographic separations on surface energy traps: decoupling the LC and the mass spectrometer

A Pressure-Driven Capillary Electrophoretic System with Injection Valve Sampling.

Rapid Analytical Method Development Using Multiparallel Microfluidic High-Performance Liquid Chromatography in Support of Pharmaceutical Process Research

Automated high-speed CE system for multiple samples

High Throughput Screening of Chromatographic Phases for Rapid Process Development

Evaluation of injection systems for open tubular liquid chromatography

Expediting Online Liquid Chromatography for Real-Time Monitoring of Product Attributes to Advance Process Analytical Technology in Downstream Processing of Biopharmaceuticals